Page 2 Page 3
Warning
This sprayer is not to be used with solvents, caustic chemicals, acids or concrete
curing products.
Do not use flammables in this sprayer.
Safety Instructions
Read Product Manual completely before operating this sprayer.
Always refer to mixing and safety instructions as specified by chemical supplier.
Always wear protective gloves, clothing and safety goggles whilst preparing, operating
and cleaning this sprayer.
Prior to use inspect hose and all hose connections. A damaged hose, or loose hose
connection can result in unintended exposure to the pressurized chemical, resulting
in serious injury or property damage.
Prior to refilling, servicing or storing you will need to release the pressure in tank by
slowly pulling up on the safety valve until all air has been released.
Do not lift or carry sprayer by the hose, shutoff valve, or wand extension. Lift by Pump
handle only (making sure pump handle is properly locked in place before lifting).
Avoid spraying in windy conditions to prevent drift of chemicals.
Keep the sprayer and all chemicals out of the reach of children.
Contents
1. Pump Handle
2. Safety Valve
3. Shoulder Strap
4. Pump Assembly
5. Sprayer Tank
6. Telescopic Lance &
Nozzle Connectors
7. Trigger
8. Hose
9. Adjustable Spray
Nozzle
1. Prior to filling, release
tank pressure by lifting the
safety valve.
2. To fill tank, remove
pump by unscrewing
pump handle in a anti-
clockwise direction.
3. Fill tank with desired
liquid to required level.
Do not exceed the “MAX”
fill level on tank.
4. Insert pump handle and
tighten by screwing in
clockwise direction.
5. Pressurise tank by pumping
handle up to 25 times. Then
lock handle into tank to allow
you to carry the sprayer.
6. Do not over pressurise.
If pressure is too high, air will
release through safety valve.
7. Start spraying by holding
down the trigger. For
continuous spraying the
trigger can be locked.
8. Turn the adjustable nozzle
to obtain desired spray pattern
–from mist to jet.
Cleaning Instructions
For sprayer longevity please follow these instructions after every use:
Release pressure via trigger or lifting safety valve.
Empty any left over contents in a safe manner.
Fill tank 1/4 full with clean water.
Pressurise and then hold trigger down to empty entire tank via nozzle.
Thoroughly rinse all components with clean water.
Storage
Do not store with contents in tank. This will destroy your sprayer mechanism.
Do not store pressurised. Lift safety valve to release pressure.
Store out of sunlight.
