Car-Interface CI-JBTAUX-2G Installation guide

CI-JBTAUX-2G
Multimedia player for CAR
1.Introduction
QUICK MANUAL
AUDI MMI 2G
CI-JBTAUX-2G module is controlled by factory mounted multimedia system
„Audi MMI: Baisic, 2G. This device uses 6-disc CD changer interface, extends
MMI network of ability to connect Line Input and streaming audio from mobile
devices by Bluetooh interface. This device support basic functions to control
playback (PLAY,PAUSE,NEXT,PREV,FF,REW) and can display a tittle, album
and artist name of current playing song.
1. Tostart playing audio sound from CI-JBTAUX-2G in first step is
recommended to press a CD/TV button on control panel. Next press a button
which control SOURCE function.
2. Select CD from displayed list of available devices. pic.1.
pic.1
2.Start Up

2.2.Start up
After CD device is selected it is recommended to press a button which control
CHANGER function.
Watch out! CHANGER label allows to switch between audio sources from
JAUX_BT and between next discs from CD changer too (if it is connected to
system).
pic.2
Selecting CD1 causes playing sound from additional line input which is
implemented in CI-JBTAUX-2G device.
Selecting CD2 causes playing sound from Bluetooth pic.2.
Also the device stores last used audio source and with next startup system
automatically plays sound from AUX or Bluetooth source.
Watch out! Additional line input AUX is not able to control external devices.

3.Bluetooth manual
CI-JBTAUX-2G module allows pairing a new device only if Bluetooh audio
source is active and other device is not paired with module in the same time.
pic.3.
View of display without connected device. pic.3
It is recommend to start Bluetooth in smart phone (or other device) and run
search function. “JUNA_AUX” should appear on list. pic. 4.
pic.4
Foundthedevice.

4.Bluetooth manual
After selection of “JUNA_AUX”, it is necessary to input a PIN code 2831 pic.5
pic.5
After a pairing with device finished correctly, smart phone should start playing
music automatically.
A screenshot of the connected devices. pic.6
Device name
Song title
Album name
Artist
Track time

5.Reconnect
The device is automatically trying to reconnect with last paired device. This
function is active after MMI system startup. If the connection is not established
then this function is active only when Bluetooth is selected from CDC lable as
current audio source. JAUX_BT is trying to establish connection with 30
seconds interval with last paired device. In this time module is visible for
connection with new device too.