Cardboard Studio I-COZY-hedron User manual
©2020 cardboard.studio. All Rights Reserved.
I-COZY-hedron
Assembly Instructions
Cardboard.Studio
www.cardboard.studio
©2020 cardboard.studio. All Rights Reserved.
Zipties
x200
DO NOT LEAVE OUTDOORS
Rain or even overnight dew/moisture will
degrade and/or destroy the cardboard
I-COZY-hedron
Included Parts
©2020 cardboard.studio. All Rights Reserved.
Step 1
Folding Flaps
Place a straight egde along the dashed line.
With the ap hanging over the edge of a table
gently pull up to fold the ap.
Fold aps on all of the pieces
TIPS: Running a thin smooth object (i.e. popsicle
stick, bone folder, etc.) along the dashed
line to begin a crease in the cardboard will
make it easier to bend. Be careful not to cut
through the cardboard though.
©2020 cardboard.studio. All Rights Reserved.
Step 2
Assemble Top Pentagon
Gather all of Triangle 3
Arrange so that all of the numbers are in
the center of the pentagon. The long side of
the triangle should be on the outside of the
pentagon.
Using two zipties, attach each triangle to one
another.
Repeat six times until you have used all of the
Triangle 3 pieces.
TIPS: The I-COZY-hedron may be assembled with
the aps on the inside for a smooth exterior
surface but it is more dicult to assemble.
©2020 cardboard.studio. All Rights Reserved.
Step 3
Connect Sides
Gather all of Triangle 2
Using two zipties along each edge connect all
of the triangle 2 to the edges of the pentagon
top like below.
They will all want to fold in on themselves.
©2020 cardboard.studio. All Rights Reserved.
Step 4
More Connecting
Gather all of Triangle 1
Attach along each edge using two zipties to
the sides of triangle 2.
The I-COZY-hedron will begin to stand up.
©2020 cardboard.studio. All Rights Reserved.
Step 5
Connect Bottom Corners
Gather all of the corner pieces.
Attach each corner to each intersection of
three triangles around the bottom opening of
the I-COZY-Hedron.
©2020 cardboard.studio. All Rights Reserved.
Step 6
Trim Zipties (Optional)
Using scissors or wire cutters trim the tails o
of all of the zipties.
WARNING: This may leave sharp edges!
Be sure to cut as close to the connector
as possible and as perpendicular to the
tail as possible. An agled cut may leave a
sharp protrusion from the ziptie.
Step 7
Climb in and
get COZY!
Table of contents
