Cardin S449 QZ2 Owner's manual

http://www.remotecontrol-
express.com
CARDIN S449 QZ2
–
rogram
ming of your new remote control
There are several
methods for programming your new
From a remote control t
hat has already been programmed
1.
Approach your motor so you are
2.
With a sharply pointed object, press the hidden button from your already
remote control (diagram above, 1). The receiver emits a beep. Let the button
3. ress a button on
your already
the button go.
4.
ress the button you wish to program
beeps. Let the button
go
5.
Repeat this procedure for each button you wish to program.
6. Wait 10 seconds.
7. Your new remote
control is programmed.
Programming Manual
express.com
- TEL : [phone] - FAX :
[phone]
–
S449 QZ4 – S449 QZ4M -
S486 QZ2
ming of your new remote control
:
methods for programming your new
remote control.
hat has already been programmed
:
Approach your motor so you are
standing a few feet away from it.
With a sharply pointed object, press the hidden button from your already
remote control (diagram above, 1). The receiver emits a beep. Let the button
your already
-programmed remote control.
The receiver emits a beep. Let
ress the button you wish to program
on your new remote control.
The receiver emits 2
go
.
Repeat this procedure for each button you wish to program.
control is programmed.
[phone]
S486 QZ2
- QZ4
With a sharply pointed object, press the hidden button from your already
-programmed
remote control (diagram above, 1). The receiver emits a beep. Let the button
go.
The receiver emits a beep. Let
The receiver emits 2

http://www.remotecontrol-
express.com
From the receiver :
1.
Open the casing of your receiver. It is located next to your motor.
2.
On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
it pressed down. The LED light of the
3.
While keeping pressed down the button MEMO, press the button you wish to program
your new remote control until the LED light of the receiver turns off.
4. Let the buttons go.
5.
The LED light of the receiver blinks.
6. ress the button on
your n
7.
The LED light of the receiver turns off.
8.
Repeat this procedure for each button you wish to program.
9. Wait 10 seconds.
10.
Your new remote control is programmed.
Programming Manual
express.com
- TEL : [phone] - FAX :
[phone]
Open the casing of your receiver. It is located next to your motor.
On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
it pressed down. The LED light of the
receiver blinks.
While keeping pressed down the button MEMO, press the button you wish to program
your new remote control until the LED light of the receiver turns off.
The LED light of the receiver blinks.
your n
ew remote control again. Let it go.
The LED light of the receiver turns off.
Repeat this procedure for each button you wish to program.
Your new remote control is programmed.
[phone]
On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
While keeping pressed down the button MEMO, press the button you wish to program
on