Carefree of Colorado OMEGA II User manual

052509-001r1 1 March, 2005
CAREFREE
OMEGA II PULL STRAP UPGRADE KIT
RV
Models: Omega II
Purpose: The center pull strap has been improved to provide the user
improved accessibility.
Summary of Work: This action consists of removing and replacing the case; and,
removing and replacing the center pull strap.
COMPONENT CHECK LIST
COMPONENT QTY COMPONENT QTY
•Case Assembly 1 •Clip, Strap 1
•End Cap, LH 1 •Set Screw 1
•End Cap, RH 1 •Screws 10
•Pull Strap Assembly 1 •3/16” Pop Rivets 4
(The rubber grommet is installed on the pull strap assembly.)
INSTALLING THE STRAP
1. Extend the slide-out room completely.
2. (Detail A) Remove the four (4) screws that hold the
case onto the arms. Then remove the case.
3. Pull the awning down and secure using one of the side
tie-down straps.
4. (Detail B) Slide the unused tie-down strap and the
center pull strap off the roller.
5. Slide the new center pull strap into the slot and
center on the rollbar.
6. Slide the tie-down strap into the slot of the rollbar.
The strap can be moved horizontally along the
rollbar to align with the existing strap catch.
7. Retract the awning to the vertical position.
INSTALLING THE CASE
3/16"
Pop Rivet
Plastic
Bezel
Rubber
Grommet
OMEGA008
Pull Strap
End Cap
Case
Stow Clip
Lower Groove
Detail CDetail DDetail E
8. (Detail C) Slide the stow clip into the lower groove of the case.
9. Install the end caps with the supplied screws.
10. Slide the clip to the area of the pull strap and secure using the # 6 setscrew.
11. Lift the case up to the top of the ladders or platforms used during assembly.
NOTE: The slot in the case is in the lower half of the case.
12. (Detail D) Thread the center pull strap through the slot and plastic bezel in the case. It will be necessary to squeeze the
rubber grommet at the end of the strap to get it through.
13. (Detail E) Lift the case up and press onto the arms. Center the case over the roller and
orient the case by aligning the existing mounting holes with the holes in the case.
14. Ream the mounting holes out to 7/32” then secure the case to the arms using two (2)
3/16” pop rivets on each end.
STOWING THE STRAP
When the awning is open, the pull strap will hang down loosely. Use the pull cane and
press the pull strap grommet into the clip to keep the strap from flopping.
Outside
Tie Strap
Center
Pull Strap
Slot
OMEGA011
Case
Detail ADetail B
Clip
Pull Strap
Grommet
Pull Cane
Omega013
Manual Compliments of
Northwest RV Supply
Printed From
http://www.nwrvsupply.com

This Manual is Compliments of
Northwest RV Supply
86325 College View Road
Eugene, OR 97405
Local: 541-746-9092
Toll-Free: 866-678-7467
Fax: [phone]
http://www.nwrvsupply.com
[e-mail]
Northwest RV Supply carries a large spectrum of surplus, used, and new
RV parts and components. Please feel free to visit our website for
additional information.