Carlisle Brass LW17 User manual

FITTING INSTRUCTIONS
G
U
A
R
A
N
T
E
E
M
E
C
H
A
N
I
C
A
L
yr
LW17 Triangular Soap Tray
Fitting Instructions
1. Position Soap Tray in desired location and mark around roses with a pencil and remove the
Soap Tray.
2. Position one of the provided backplates on the wall in the centre of the marked area.
3. Mark the two screw positions.
(To stop drill wandering on a tiled surface, apply masking tape to the wall before
marking the fixing holes.)
4. Drill two holes using a 6mm drill bit to a depth of 32mm and insert wall plugs.
5. Ensure that the flat surface of the backplate is sitting against the wall and fix
backplate to wall using the screws provided making sure the backplate is straight.
6. Repeat steps 2 through 5 for the other backplate.

[phone]
[phone]
Carlisle Brass Ltd, Parkhouse Road, Carlisle, CA3 0JU
[email protected]
www.carlislebrass.com
LW17 Triangular Soap Tray
Fitting Instructions
7. Loosen the small grub screw marked ‘A’ on the bottom of the Soap Tray on
each side.
8. Locate the top groove inside one of the Soap Tray Roses.
9. Tilt the Rose and slip it onto backplate shown in the diagram below.
10. Push the Rose into position and secure by tightening the grub screw marked B.
11. Repeat steps 6 through 8 for the opposite side Rose.
12. Once both the Roses are secure, slide the Soap Tray into Rose slots and tighten
up the two grub screws marked ‘A’.
13. Make sure part is secure before intended function.
Soap Tray Rose
B
A