TF-025 TrailFinder Binocular
Instructions
Features a built-in
digital compass
Holding your binocular
Grasp each barrel firmly and move the barrels closer together or further apart until you see
a single circle of view. Always return your binoculars to this position before using.
Focusing
Close your right eye and sight an object with your left eye. Focus the binocular by rotating
the center focusing wheel until the image is sharp and clear.
Open your right eye and close your left eye. Rotate the right eyepiece until the object
sighted is sharp and clear (note the setting of the diopter scale for future use.
Both sides (eyes) are now in focus and you will need to use only the center focusing wheel
to focus on other objects.
Rubber Fold Down Eyecups
Fold down for use with eyeglasses and fold up for use without eyeglasses. They provide
comfort and promote viewing ease.
CAUTION! Viewing the sun can cause permanent eye damage. Do not view the sun with this
binocular or even with the naked eye.
To Power on
Press “SET” to activate LCD Readout
To set auto shut off for 1-6 minutes
1. Press “MODE” twice until TM3 appears on
LCD Readout
2. Press “SET” to change display time from 1 – 6
minutes
3. Once time is selected press “MODE” to confirm
setting.
To Calibrate
1. When “WARN” displays on LCD readout calibration
is required
2. Press “MODE” twice until “CA” appears on LCD
readout
3. Press “SET” once and the LCD readout will flash
“TURN TWICE”
4. Turn compass slowly twice (360 degrees x 2)
5. Press “SET”. Your compass is now calibrated
Note: Calibration is required after replacing battery.
Battery: Lithium battery #CR2032 included
NOTE: Keep your compass as level as possible during all
procedures
Once calibrated properly, the LCD display will show the direction you are facing while looking
through the binocular. The small triangle containing the letter "N" will always point to the
north.
O
