Casall T400 User manual

This model is created from Adventure 3 for Casall only
Only the model stickers are changed
Casall T400 (TM631E-2KM)
Service Manual

TABLE OF CONTENTS
CHAPTER 1: SERIAL NUMBER LOCATION
CHAPTER 2: ENGINEERING MODE
2.1 Engineering Mode
2.2 Engineering Mode Overview

CHAPTER 1: Serial Number Location 1
1-1 Serial Number Location

CHAPTER 2:
Engineering Mode
2.1 ENGINEERING MODE
Hold both incline “▲” and speed “－” at the same
time about 3 sec to get into the engineering mode.
The display will show ENGINEERING MENU.
Use incline “▼” or “▲” and speed+/－to scroll
engineering mode from Eng0 to Eng 4. Press
“Enter” into set up parameter
2.1 ENGINEERING MODE OVERVIEW
Mode Function Description
Eng 0 Display Test
StartLED on
StopLED off
Any Keysdisplay on window
Hold “Stop” 3 secback to “Engineering Menu”
Eng 1 Hardware Test Motor , Incline motor test
Eng 2 Auto Calibration To auto calibrate speed only.
Eng 3 Switch Function Use “Start” to select unit. 1—KM, 0—Mile
Use elevation or speed to change “Demo” on or off
2nd Level
Eng 8 Software version
In Eng 3, to hold “Speed＋”/ “Incline－” into Eng 8
Press “Enter” to P0---software version
Press “Enter” to P1---select speed up rate—Normal/Quick
Press “Enter” to P3---Hold “Start” 3 sec to clear all data.
Eng 4 Information
Accumulated Time and Distance
Hold “Start” 5 sec to reset
Remarks: Unit of Time is Hour.
Unit of Distance is KM or Mile based on your set.