Operation Guide 3305/3307
1
MA0307-EA
[Module 3307]
To Set Time
1) Pull the crown out when the second hand is
at 12 o’clock position and the second hand
stops.
2) Turn the hands clockwise and put the watch
four or five minutes forward. Then back them
out.
3) In accordance with a time signal, push the
crown in.
[Module 3305]
To Set Time
1) Pull the crown out to the second click when
the second hand is at 12 o’clock position and
the second hand stops.
2) Turn the hands clockwise and put the watch
four or five minutes forward. Then back them
out.
3) In accordance with a time signal, push the
crown in.
To Set Date
1) Pull the crown out to the first click.
2) Set the date by turning the crown clockwise.
3) Push the crown in to the normal position.
Display Illumination Precautions
The light that illuminates the face uses two LEDs (light-emitting diode) and a light guide
panel that cause the display to glow for easy reading in the dark. The face remains illumi-
nated as long as you keep Ldepressed.
•The illumination provided by the light may be hard to see when viewed under direct
sunlight.
•Frequent use of the light shortens the battery life.
■Avoid setting the date between 8:00 p.m. and 1:00 a.m.
(the date display may not change in the following day).
■For watch with the elapsed time bezel
Rotate the elapsed time bezel to align the mark with the
minute hand.
After certain amount of time elapsed, read the graduation
on the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
First click
(Setting date)
The configuration of your watch
may differ somewhat from that
shown in the illustration.
Second click
(Setting time)
Crown
(Normal position)
L
(Light button)
•Some water resistant models are equipped with a screw
lock crown.
•With such models, you must unscrew the crown in the di-
rection noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
•Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
Crown
L
(Light button)
30
50
40
30
20
10
Elapsed time bezel
