
1
Operation Guide 5318/5456
MA1501-EA
#!3)/#/-054%2#/,4$
xYour watch may differ somewhat from the one shown in the illustration.
Click 1
Day of the week
24-Hour Hand
Day
Crown
Click 2
Crown Operations
Crown
Loosen
Some water-resistant models (100 meters, 200 meters)
have a screw-in crown. When you need to perform a crown
operation, rotate it towards you to unscrew it. Then pull the
crown out. Avoid applying undue force when pulling. The watch
loses its water resistance while the crown is unscrewed. After
performing a crown operation, fully screw the crown back in.
If your watch has a rotary bezel...
Start
Elapsed time
Current
You can rotate the bezel to align its ▼mark with the
minute hand. Then you will be able to tell how much
time has elapsed since aligning the ▼mark.
Specifications
Accuracy: ±20 seconds average per month
Illumination: 5318: Ultraviolet LED (light-emitting diode)
5456: LED (light-emitting diode)
Battery: One silver oxide battery (Type: SR621SW) and one lithium battery (Type:
CR1616)
Battery Life: Approximately 3 years on type SR621SW and type CR1616 (assuming one
9-second illumination operation per day)
xAlways have both batteries replaced at the same time.
Illumination Precautions
xIllumination may be hard to see when viewed under direct sunlight.
xFrequent use of illumination runs down the battery.
To change the day setting
Note
xThe day setting uses a
31-day month. Make
adjustments for months of
shorter lengths.
xAvoid changing the day
setting between the hours
of 9 p.m. and 1 a.m.
Otherwise, the day setting
may not change correctly at
midnight.
Pull the Crown out to Click 1.
Rotate the Crown to set the day.
Push the Crown back in.
To turn on illumination
Note
xIllumination remains turned on as long as Lis depressed.
xIllumination will turn off about four seconds after Lis released.
Hold down L.
To adjust the day of the week and time
When the second hand is at 12o’clock, pull
the Crown out to Click 2.
Rotate the Crown to advance the hour and
minute hand settings, which will also change
as the day of the week setting.
Note
xTake care that you set the
correct AM or PM time.
xWhen changing the time,
move the minute hand four
or five minutes past your
final setting, and then back it
up to the setting you want.
xThe 24-Hour Hand indicates
the current hour of the day.
It makes one complete
rotation every 24 hours.
Rotate the Crown to change the time setting.
Push the Crown back in.