Cassellie SEA008 User manual

A ( 1 : 1 )
A
Remove seat from packaging and locate
4x small self tapping screws.
Put these safely to one side.
Familiarise yourself with the adjustment points.
Adjuster "A" is for hole size changes
Adjuster "B" is for hole depth changes
Open the handle and locate the two pins into the holes in the toilet pan.
Close the handle, it should take a small amount of pressure to close the handle
If the handle is too hard to close, STOP, remove the seat and adjust the adjuster
counter-clockwise half a turn then refit.
If the handle is really easy and does not clamp the seat to the pan, remove
the seat and adjust the adjuster clockwise half a turn and refit.
While the lid is clamped down, slide it to your
prefered position on the toilet pan.
Hold the base of the hinge while opening
the handle to reveal the adjuster plates.
Straighten up the adjustment covers and screw in ONE Screw
per adjuster while holding the seat in the correct position.
Check alignment by locking down the handle, once happy
with the position, add the second screw to each cover.
Once fitted if there are any problems, consult the troubleshooting
sheet.
1. 2. 3.
4. 5.
Adjuster "A"
Adjuster "A"
Adjuster "B"

TROUBLESHOOTING TABLE
Problem: Solutions:
Handle is too tight to push down Turn Adjuster "A" Counter clockwise half a turn at a time
Handle is too easy to push down Turn Adjuster "A" Clockwise half a turn at a time
Seat moving around when handle is down Check fixing screws are securing adjustment cover to base
Seat hinge loose when handle is down Look under pan, check 2-3mm of rubber is visible when handle is down
and correctly adjusted to pressure To increase amount of rubber visible, turn adjuster "B" counter clockwise half a turn at a time
To decrease amount of rubber visible, turn adjuster "B" clockwise half a turn at a time
Seat has become loose over time Turn adjuster "A" clockwise half a turn at a time to compensate for any wear over time.
Adjuster "B"
Adjuster "A"
Adjuster "B"
Adjuster "A"
Adjustment covers
Adjustment cover
screw holes