
RECHARGEABLE HEADLIGHT
HL-EL560G RC
K 1191
Manual
Design Pat. Pending
Copyright© 2017 CATEYE Co., Ltd.
HLEL560GRC-171031 5
Cartridge
battery
(BA-3.4)
Before using the light, please read this manual
and the included separate sheet “LITHIUM-ION
/ LITHIUM-ION POLYMER BATTERIES” thor-
oughly, and keep them for future reference.
HOW TO MOUNT TO A BICYCLE
2
HOW TO CHARGE
1
WARNING!!!
• Be sure to direct the light beam downward so the driver ap-
proaching does not get dazzled.
• Before your trip, please make sure the light is firmly mount-
ed to the bracket and it lights up.
• Always attention to the remaining battery power by check-
ing the indicator periodically while using.
CAUTION!
• Do not place it within children’s reach.
• In preparation for unexpected battery shutoff, we recom-
mend you carry a spare cartridge battery and light.
• Mounting the light unit too close to a wireless computer
may adversely affect the reading of the computer.
• This product is water-resistant under normal daily use and
can be used in the rain. However, do not intentionally sub-
merge it in water.
• If the light unit or parts become dirty with mud, etc., clean
with a soft cloth which is moistened with mild soap. Never
apply paint thinner, benzine or alcohol; damage will result.
• Dispose of used cartridge batteries appropriately according
to local regulations.
Before Initial Use
This unit is shipped with a small charge to check the light.
Be sure to charge it before use, according to the instructions
“HOW TO CHARGE”.
1. Connect the light unit to your PC or a com-
mercial USB battery charger using the USB
cable. ( 1– 2).
The switch indicator turns on and charging
starts.
* If using a cradle (optional), the indicator on
the cradle turns on.
Indicator light State
On Charging (500 mA charging)
Flashing slowly (1 A charging)
Off Charging is completed
* When your PC is in sleep state, the unit can-
not be charged.
* Use a USB battery charger of 500mAh
(USB2.0) or more. The cartridge can be
fast-charged with high capacity USB battery
charger.
* If the indicator flashes rapidly, there is a
charging error. Remove the cable and try
again.
2.
After charging is completed, remove the
USB cable, and install the charge jack cover.
* Charging and lighting times are approximate
values, and will vary by environmental and user
conditions.
* The optional cradle2 not only lets you charge
the battery by itself, but also gives you the op-
tion of using it as a mobile battery.
Light unit
FlexTight™ bracket
(H-34N)
USB cable
(MICRO USB)
DialRubber padBracket
Strap
1. Mount the bracket to the handlebar.
(1– 3)
2. Insert the light unit into the bracket until
it clicks, and adjust the beam angle. ( 4)
3. To remove the light unit, pull out it for-
ward while pressing down on the release
button ( 5).
* To re-adjust the beam angle, loosen the
dial enough to move the bracket, and firmly
tighten it after adjustment.
* The light can be mounted under the handle-
bar.
CAUTION!:
• Be sure to tighten the dial by hand.
When you tighten it too hard with a tool,
the screw thread may be stripped.
• Check the dial and screw (*1) on the
bracket periodically, and use them
without any loosening.
• Round off the cut edge of the bracket
strap to prevent injury.
2
1
3
4
4
IN
OUT
OUT
IN
OUT
OUT
MICRO
USB
USB
IN OUT
Fast charging cradle 2
Charging on the cradle
Cartridge battery
Screw
*1
ENG
2
1
Charge jack cover
USB cable To PC or USB
battery charger
5
Release
button
Standard charging time
Approx. 5 – 9 h