CDA SVW101 Reference manual

1
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T: 01949 862 012 F: 01949 862 003 E: [email protected] W: www.cda.eu
Passionate about style
SVW101 Drawers
Manual for Installation, Use and Maintenance

2
Important
This appliance must only be used for the purpose for which it is intended, i.e. storage. Any other use could be dangerous
and may lead to premature failure of the appliance.
Appliance information:
Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a
fault with your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
Important
• Do not rest or sit on the drawer when open, as this will damage the telescopic runners.
• The maximum capacity of the drawer is 20 kg.
• Do not cover the bottom of the drawer with aluminium foil or other objects.
Use only the supplied mat.
• To avoid scratching, do not drag dishes on the bottom of the drawer.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY FAILURE TO
OBSERVE THESE INSTRUCTIONS.
Before first use
Before using the drawer for the first time we recommend that you clean it with a damp cloth, then dry thoroughly.

3
Install
Check the measurements on g 3 to conrm the requirements for
your installation. Please note, the oven dimensions show a standard
CDA oven and will vary depending on the appliance being installed
above the drawer.
1. Locate the product centrally on the supporting shelf and x into
position using the xing screws and plastic supports (g 2).
2. Carefully t the appliance on top of the warming drawer, taking
care not to scratch the top stainless edge of the drawer unit.
4. Secure the oven into the housing using appropriate xing screws.
5. The drawer is supplied with three metal filler strips with
a self-adhesive backing. These strips should be attached to the
drawer to seal any gaps between the appliance and the
housing. Remove the protective foil from the trim and position
the trim as shown in fig 1 so they are flush with the rear and side
walls of the housing, then attach to the drawer. If there is
no rear wall to the housing, the rear trim is not required.
Fig. 1
Fig. 2
Fig. 3
7
573
20-24
594
598
595
715-720
560-568
548
23
128
537
141
6

4
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T: 01949 862 012 F: 01949 862 003 E: [email protected] W: www.cda.eu
Passionate about style
To contact our Customer Care Department, or for Service,
please contact us on the details below.