CDB iGlo User manual

INSTALLATION:
CAUTION:
•Ensure all packaging materials are fully removed prior to installation.
•Unravel the strip light fully.
1) Select the appropriate mounting position, make sure the power supply can be plugged in without
excessive tension on the cable.
2) Clean the surface thoroughly to ensure maximum adhesion, make sure it is dry prior to
installation.
3) Measure and cut the LED strip to the correct length (if required), be careful no to cut the wrong
end. Review the product carefully prior to cutting, only one end allows the power supply to be
connected.
4) Remove the backing tape gradually while applying the strip light to the surface. Apply in short
lengths to minimise mistakes. Do not use excessive pressure to attach the strip light to the
surface.
5) Once fully applied connect the power supply using the pin connectors on each end of the light
and power supply. Complete this process carefully to avoid any damage.
6) Plug into a wall socket and turn the switch ‘ON’.
7) Your light is now ready to use.
SMART FEATURES (COLOUR CHANGE, DIMMING ETC):
This product can be controlled by either a remote or via the Smart Lighting App (in the case of the Wifi
enabled model). Please read the iGlo user manual (enclosed in box) for detailed operating
instructions.
INSTALLATION GUIDE:
5M LED STRIP LIGHT

BUCKET &
SPONGE
WIPES
New Zealand
PO Box 100-707
N.S.M.C
Auckland
Phone [phone]
Phone [phone]
[email protected]
Australia
PO Box 574
South Morang
Victoria, 3752
Phone [phone]
Phone [phone]
[email protected]
BEFORE STARTING PLEASE NOTE THE FOLLOWING:
Always read the instructions carefully before installation, failure to do this could result
in damage to the product, property or harm to the installer.
Do not touch the LED light source when it is on or until it has cooled down.
It is recommended that this product be used on a circuit board protected by an Earth
Leakage Circuit Breaker or Safety Switch.
Allow suitable ventilation around the light fitting and do not cover with any material.
Do not immerse any part of the light fitting in water or any other liquids.
Regularly inspect the light fitting to ensure that no damage has occurred, if damage is
found cease use and replace.
Do not attempt to modify this fitting in any way.
The LED Driver is not replaceable.
LUMINAIRE SPECIFICATION:
Models…………… IGST5M-WF
Length…….………………… 5 meters
Input Voltage……………… 220 ~ 240 Volts 50Hz
Wattage…….………………… 24W
Light Source………………… LED
Use………………….…………. Indoor Only (Permanent Use)
Operating Position……… Vertical or Horizontal Surface
5M LED STRIP LIGHT
5M LED STRIP LIGHT
TOOLS GUIDE:
N.B. The list below is a guide only, use these to prepare your surface prior to installation.
Surfaces should be clean and free of dust, grime and dirt to ensure maximum adhesion.
SCISSORS /
CUTTERS