
User Instructions for Toilet Surrounds
T76 –T77 –T78 –T76R –X154 –X155
Ref: Toilet surrounds June 2020
Form No: Cef 0035
Assembly Instructions
Please note:
When unpacking carefully examine the product to ensure it is complete.
Before use check for any damage. If damaged please contact your supplier
and refrain from using the product.
Do not attempt to use if the product is damaged.
Correct Use
Height Adjustment
Remove the pin clip from each of the legs.
Select the required height of the frame by gently sliding each extension leg in
or out.
When desired height is found refit the pin clip into the appropriate hole in each
extension leg.
Ensuring it goes fully through. Ensure that all legs are set to the same height.
Cleaning
This product can be cleaned using a mild detergent and a mild disinfectant or
antibacterial solution. The framework should be wiped down on at least a
weekly basis. Caution must be taken to understand the suitability of cleaning
agents/chemicals being used.
Do not use an abrasive cleaner as this may damage the frame and invalidate
your warranty.
It is recommended that the potty is thoroughly cleaned after every use, using
an appropriate cleaning agent.
Use of power/jet washing & industrial washing machines
If either of the above is used to clean equipment care must be taken since
high-pressure water can be penetrative.
Care should be taken that frames are not placed too close to high-pressure
water jets.
After cleaning ensure any residual water is removed from the framework as it
could cause permanent rusting of the frame (leave frames open in a warm
environment for several hours to ensure all internal moisture evaporates).
We cannot offer advice on industrial washing machines with regards to
specific machine settings, as these will be dependent on the manufacturer’s
instructions.