CellGate Watchman WXL User manual

Quick Install Guide
2020
AA1XLPE Devices
INSTALLER TEST CODE:
CODE WILL STOP WORKING AFTER 10 USES.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Technical Support: 972-231-1999 option 2
18 gauge stranded - up to 25 ft
16 gauge stranded - up to 50 ft
12 gauge stranded - up to 60 ft
Recommended Wire Guide
WXL

**Recommended wiring: 18/6 shielded for main device, and 18/4 shielded for optional wiegand devices**
Items Included in Kit
❶WXL Unit
❷12 Volt DC Power Supply
❸Magnetic Read Switch
❹Keys (Note: Leave one key with the customer)
❺Nuts X 4
❻Bolts X 4
❼Quick Install Guide
❽Activation & Test Process
❾Customer Information Packet
WXL Unit Power Supply Wiring
Interface Circuit Board (Oriented the same as the Watchman install)
WXL
-
Router
Interface
Circuit
Board
Ethernet
Switch
WATCHMAN
Important Item

Interface Wiring Diagram (Oriented the same as the Watchman install)
❶Wire main power from the transformer to the power connector on the
circuit board.
❷Connect gate trigger wires from the Normally Open (NO) and Common (C)
to the free-exit or exit terminals on the gate operator.
❸Connect the gate status wires on the 6-pin connector on the main relay
and input plug to the magnetic switch or a Dry Contact, Normally Closed (NC)
relay on the gate operator.
❹If using an optional 26-bit reader (ex., keypad, card reader, RFID, or
clicker), wire the device to the Wiegand connection on the interface circuit
board.
❺Use Camera Guide if adding optional external camera.
❻Test/activate using the test credentials on the Activation & Test Process
document.
6-Wire Installation Instructions
Important Item
WXL
18 gauge stranded - up to 25 ft
16 gauge stranded - up to 50 ft
12 gauge stranded - up to 60 ft
Recommended Wire Guide
WATCHMAN
❶
❷
❹
❸

Installation Testing
Enter the Testing Code, then tap the Enter Button.
The Code will activate Relay 1 (the gate should open).
Enter Button
Locate a Callgroup and tap on it to call it.
An automated message will play confirming the call
was successful.
WXL
Enter a Code
Call List
Home
WATCHMAN

External Camera Installation.
Customer Information
•If you’re installing an External Camera, call
CellGate Technical Support for testing.
•Technical Support:[phone] option 2.
Leave the following items with the Customer:
•Customer Information Packet
•WXL - Key
WXL
WATCHMAN