Celsius CELMH120 User manual

For model: CELMH120
MICATHERMIC HEATER
OPERATING INSTRUCTIONS

1. Use only the voltage specified on the rating
label of the appliance.
2. Keep all objects at least 1 metre from the front,
sides and rear of the appliance. Do not place
appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this
may cause an electric shock, fire or damage to
the appliance. Do not sit on the appliance.
5. Do not operate this appliance with a damaged
cord, plug or after the appliance malfunctions
or has been dropped or damaged in any
manner. Return to a qualified electrical person
for examination, electrical service or repair.
6. This appliance is intended for household use
only and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended by
the manufacturer and may cause fire,
electrical shock or injury.
8. The common cause of overheating is deposits
of dust or fluff in the appliance. Ensure these
deposits are removed regularly by unplugging
the appliance and vacuum cleaning the air
vents and grills.
9. Do not use abrasive cleaning products on this
appliance. Clean with a damp cloth (not wet)
rinsed in hot soapy water only. Always remove
plug from the mains supply before cleaning.
10. Do not connect the appliance to mains supply
until completely assembled and adjusted.
11. Switch off and use handles provided when
moving.
12. Do not operate with cord set coiled up as a
heat build up is likely, which could be sufficient
to become a hazard.
13. It is recommended that this heater is plugged
directly into the wall socket. Power boards are
not rated to supply power to high wattage
appliances.
14. A correctly specified, undamaged extension
cord may be used with this heater provided it
is used in a safe manner.
15. Do not remove plug from power socket until the
appliance has been switched off.
16. Do not remove plug from power socket by
pulling cord; always grip plug.
17. Always unplug appliance when not in use.
18. Do not locate the heater directly below any
power socket during operation.
19. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord
has been removed from any cord storage area
and is unrolled before use.
20. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge, unless they are
supervised or have been given instruction
concerning the use of the appliance by a person
responsible for their safety.
21. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not be
immersed in any liquids.
22. When the appliance has been unpacked, check
it for transport damage and ensure all parts
have been delivered. If parts are missing or the
appliance has been damaged, contact the
Celsius Customer Services Team.
23. If your appliance does not work, or is not
working properly, contact the place of purchase
or the Celsius Customer Services Team. Repair
work on the appliance by unqualified persons
can cause serious risk to the user.
24. There are no user serviceable parts installed in
the unit.
25. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire
hazards.
26. This unit is not supposed to be used in or
around locations where foodstuffs, works of art
or delicate articles of science, etc are stored.
27. Indoor use only.
28. Children should be supervised to ensure that
they do not play with the appliance.
29. Ensure heater is on a flat, stable, heat-resistant
surface.
30. It is important that you do not cover this heater.
WARNINGS AND SAFEGUARDS
Celsius –New Zealand
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]
Celsius –Australia
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]
SUPPORT AND TECHNICAL ADVICE

Micathermic heating uses both radiant and convection heating technology. Natural
convection currents distribute the heat evenly throughout the room, while radiant
heat from the heating surface warms people and objects in the room. This heater is
equipped with two heat settings.
1. Main Body
2. Cord Tidy
3. Castor Bracket
4. Castors
1. Power Indicator Light
2. Heat Control Dial
3. Thermostat Control Dial
3
1
2
3
2
1
4
ASSEMBLY
1. Carefully turn the heater upside down.
2. Align the holes in the wheel bracket with the holes in the base of the heater, place screws in the
centre of the holes and attach firmly with a screwdriver.
3. Repeat for other wheel bracket.
4. Turn the heater the right way up.
The screw pack to attach the feet to your heater will be taped to either one of the feet for
your heater, or taped to the plug head.
COMPONENTS

OPERATING YOUR HEATER
Always choose a safe location for the heater, keeping in mind the safety precautions
outlined. Ensure all packaging has been removed from the unit before use. This appliance
requires no installation, it should be used solely as a portable appliance.
WARNING: THIS IS A DOUBLE SIDED HEATER. Keep all objects at least 1 metre from the
front, sides and rear of the appliance.
Note: When the heater is turned on for the first time, it may release a slight, odour or smoke.
This odour or smoke is a normal occurrence caused by the initial heating of the internal
heating elements and should not occur again.
HEAT CONTROL DIAL
The control switch positions are:
O - Power Off I - Low Heat II - High Heat
Check that the heat control switches are set to Off position before plugging the heater into
the mains supply. For greater economy, use the High Heat setting initially and then switch to
the Low Heat setting.
THERMOSTAT
Turn the thermostat knob clockwise until you reach the maximum temperature on the
graduated scale. When the desired room temperature is reached, slowly turn the knob anti-
clockwise until the heater turns off (you will hear a click). The heater will now cycle on and
off to maintain the set temperature.
CAUTION
The Micathermic Heater generates heat during use. Proper precautions must be taken to
prevent the risk of burns, scalds, fires or other damage to persons.
IMPORTANT! NEVER COVER THIS HEATER!

SAFETY DEVICE
This appliance has three protection devices. The first device will automatically turn the
appliance off if the appliance is not in the appropriate operating position.
The second device automatically disconnects & reconnects the appliance at a pre-set
temperature.
The third device disconnects the appliance permanently in case of overheating, by means of
a thermal fuse (it is non resettable).
Do not use this heater with a programmer, timer, separate remote-control system or any
other device that switches the heater on automatically.
CAUTION: The heater generates heat during use. Proper precautions must be taken to
prevent the risk of burns, scalds, fires or other damage to persons.
CLEANING YOUR HEATER
The heater requires regular cleaning to ensure trouble free operation:
Unplug the heater from the mains supply before cleaning.
Ensure that the heater has been allowed to cool down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.
Use a vacuum cleaner to remove dust and fluff from around the grills.
Never use solutions such as benzene, thinners or polishing agents.
Ensure the heater is dry before plugging back into the mains supply.
Do not attempt to dismantle the heater. There are no user serviceable parts. For service or
repair, contact an authorised electrical service technician.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase.
TECHNICAL SPECIFICATION
Model No: CELMH120
Supply: 220-240VAC 50Hz
Wattage: 1300-1500W

Thank you for purchasing this Celsius product. Your product is warranted against faults and manufacture when used in
normal domestic use for a period of one year. In non-domestic use Celsius limits the voluntary warranty to three
months.
Celsius undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault
during the warranty period.
This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried out
by anyone other than a qualified electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in
relation to the goods or services to which this warranty relates.
In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).
One Year Warranty
Celsius One Year Warranty (IMPORTANT: Please complete and retain this warranty card)
Name
Address
Place Of Purchase Date Of Purchase
Name Of Product Model Number
Attach a copy of the purchase receipt to this warranty card
Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product.
Celsius –New Zealand
PO Box 100-707
N.S.M.C
Auckland
Phone [phone]
Phone [phone]
[email protected]
Celsius –Australia
PO Box 574
South Morang
Victoria, 3752
Phone [phone]
Phone [phone]
[email protected]