CF MOTO 9DSV-805100-6000 Parts list manual

1
ACCESSORY SETUP INSTRUCTION
WINDSHIELD ASSY -- PN: 9DSV-805100-6000
VALID FOR: MY2020 and Newer CFORCE 600
BEFORE YOU BEGIN: Read and understand the instructions before starting any work. Make sure that all parts are
ready and that you have all the tools required for assembly.
NOTE: CFMOTO shall not be liable for any damage caused by incorrect assembly. CFMOTO recommends that all
original accessories be assembled by an authorized CFMOTO dealer.
Before assembly, park the vehicle on a flat surface, put the transmission gear into Park (P) and turn offthe key switch.
Zhejiang CFMOTO Power Co., Ltd. All rights reserved. Reproduction of this document, even in part, as well as copying of all kinds, is
permitted only with the express written permission of the copyright owner.
!
MEANING OF SYMBOLS
- Indicates information with more details or tips.
- Indicates information of warning or danger.
PARTS LIST:
ITEM PART NAME PART NUMBER QTY. REMARK
1 WINDSHIELD ASSY 9DSV-805100-6000 1
For structure
reference only
2 FRONT WINDSHIELD 9DQV-805205-3000 1
3 LH WINDSHIELD BRACKET 9DSV-805101-6000 1
4 RH WINDSHIELD BRACKET 9DSV-805102-6000 1
5 RUBBER BUSHING 6KJ0-120004 4
6 SCREW M6x22 30102-060022870 4
7 RUBBER SLEEVE LINER, FRONT LICENSE BRACKET 5020-031002 4
8 NUT 30206-060570 4
9 INNER HEX SCREW M8x50 30102-080050870 4
ITEM DESCRIPTION QTY. REMARK
1 PROTECTIVE GLOVES 1
Recommended Tools
2 10mm WRENCH 1
3 4mm ALLEN WRENCH 1
4 6mm ALLEN WRENCH 1
TOOL LIST:

2
∥Pull up and remove the handlebar guard (A).
∥Remove the four handlebar clamp screws (A).
NOTE: These screws will not be reused.
A
ASSEMBLY AND INSTALLATION
∥Place the LH & RH windshield bracket (3 & 4) under
the handlebar clamp blocks (A) as shown, align
the thread holes, then install and torque the M8×50
screws (9) to specification.
NOTE: When possible, do not disturb the handlebar
clamp block positions for easier reassembly. Realign the
handlebar position as necessary and tighten the screws to
the proper torque specification.
∥Install the rubber bushings (5) into the corresponding
holes on the front windshield (2).
A
A
4
3
A
9
2
5
INNER HEX SCREW M8×50 30102-080050870 20-30N.m

3
∥Install rubber sleeve liners (7) into the corresponding
rubber bushing holes on the front windshield (2).
∥Align the holes on the front windshield (2) to the
windshield brackets, then install the supplied M6x22
screws (6) and nuts (8). Tighten the fasteners
sufficiently, using caution not to over-tighten.
2
7
ASSEMBLY AND INSTALLATION
∥Reinstall the handlebar guard (A).
∥The windshield assembly is complete.
A
8
6
2