Challenge DL06-1 TIMER User manual

MODEL NO.DL06-1 TIMER
2kW Convector Heater with Timer
INSTRUCTION MANUAL
Important – Please read these instructions carefully before first using
product and retain for future reference.
This product is only suitable for well insulated spaces or occasional use.
CAT.:912/1911

1

2

Only Fit 2 screws to each foot (diagonally) in the positions shown by the
black circles as shown here.

4. If not using the Timer, make sure the
Timer slide switch is set to the “I”
position.

5. To override the timer action slide the switch to either (0) for heat off or (1) for heat
on. The clock timer will continue to run but will no longer control the heater.
OPERATION with TIMER in ‘I’ (ON) position
Make sure HEATER switches are also in an ON position for the appliance to
warm up and set the THERMOSTAT dial to the desired temperature level.
(NOTE at MINIMUM ‘Frostguard’ setting the unit will only function when the
ambient room temperature drops below around 7 degrees centigrade)
With heater switches in the OFF position the unit will not warm up, even when
the TIMER is in the ‘I’ (ON) position

50-60Hz

DL06-1 TIMER
Produced in China. Argos Limited, 489-499 Avebury Boulevard, Milton Keynes,
MK9 2NW. Argos (N.I.) Ltd, Forestside Shopping Centre, Upper Galwally,
Belfast, United Kingdom, BT8 6FX. Argos Distributors (Ireland) Limited, Unit 7,
Ashbourne Retail Park, Ballybin Road, Ashbourne, County Meath, Ireland