
Slide the shorter pole (G) (figure 1) through the plastic sheeting ox and install onto the right side of the lower rear
tray on the ack of the masker. Place the top plate (E) (figure 2) on the top of the ox. Attach post (K) to the middle
race (I) (figure 3). Attach the pole (G) to the post (K) (figure 4)
I n s t r u c t i o n s
8.
Attach (3) lades (N) (figure 1), (4) tape hu s (O) (figure 2) and locking collars, springs and washers (figure 3)
11.
Figure 1 Figure 2 Figure 3 Figure 4
Attach upper race (J). This race olts to the lade
post (F) on the left side and post (K) on the right side
9.
Upper
Brace J
Attach the longer pole (G) to the left side of the lower
rear tray on the ack of the masker (figure 1) and
then attach post (L) to the upper race (J) and to the
pole (G) (figure 2)
10.
Post L
Figure 1
Figure 2
Tape Hu Locations
Figure 1 Figure 2 Figure 3
Just load your paper rolls and tape, and your Champ Deluxe Mo ile Masker is ready to e used!