Champ 4048 User manual

Auto Body Toolmart
Champ Frame Stra ghten ng Equ pment, Inc.
2545 Milleni m Dr. ~ Elgin, IL. 60124 [phone]
www.a tobodytoolmart.com
AFrame Structure
B2 - 9/16” x 3” Bolts
C3 - Light Housing
D8 - 5/16” x 2” Bolts, Washers and 4
Loc ing Nuts
E4 - 5/16” Hand Knobs
F4 - Wheels w/ Loc ing Washers and Nuts
(2 Wheels are loc ing wheels)
G4 - End Caps
Parts L st
4048 - Champ
Inspect on L ght
Read all assembly instructions completely before attempting to assemble unit.
Improper assembly could result in damage to Inspection Lig t or injury to user.
T e Inspection Lig t s ould be inspected regularly for damage. Do not use if any cracks in metal or
welds are present.
WARNING
A
F
Frame Straightening Eq ipment Inc.
Made In USA
B
C
DE
G

Attac straig t bar of t e Frame Structure
(A) wit 3” bolt (B) Fully tig ten 3” bolt (B) to straig t bar of
t e Frame Structure (A). Repeat step 1
and 2 for ot er side of Frame Structure (A)
straig t bar.
Slide 2” bolt (D) t roug ole on bracket
attac ed to Lig t Housing (C). Repeat on
bot sides of Lig t Housing (C). NOTE:
washer mus be be ween frame s ruc ure and ligh
bracke .
Place protruding 2” bolt (D) t roug provided
ole in t e bottom of uprig t Frame Structure
(A). Place Hand Knob (E) on outside of Frame
Structure (A) and tig ten. Repeat on bot sides.
Repeat step 3 for middle Lig t Housing (C).
NOTE: middle ligh will have 4 - 2” bol s (D) ha will
be igh ened wi h Locking Nu s and will no be
adjus able. Fully igh en nu s.
1. 2.
3. 4.
5. 6.
Repeat step 3 for t e top Lig t Housing (C).

Repeat step 4 for t e top Lig t Housing (C). Fully tig ten all nuts on brackets (included
and already pre-assembled) on Lig t
Housings (C).
7.
Assembled Champ Inspection Light
8.
Auto Body Toolmart
Champ Frame Stra ghten ng Equ pment, Inc.
2545 Milleni m Dr. ~ Elgin, IL. 60124 [phone]
www.a tobodytoolmart.com
Carefully lift ends of Frame Structure (A)
and slide W eel (F) t roug provided ole
in bottom of Frame Structure (A). Fully
tig ten wit locking was er and nut.
Repeat on all 4 corners.
Place End Caps (G) on end of Frame
Structure (A). Repeat on eac corner.
9. 10.