Chaney Instrument AcuRite 06045 User manual

Instruction Manual
Lightning Detection Sensor
model 06045
Features & Benets
1. Integrated Hanger
For easy placement.
2. Wireless Signal Indicator
Flashes when data is being
sent to the companion unit.
3. Interference Indicator
Flashes when interference is
detected (see page 4).
4. A-B-C Switch
Slide to select A-B-C channel.
5. Battery Compartment
6. Lightning Strike Indicator
Indicates a lightning strike has
occurred within 25 miles (40 km).
7. Battery Compartment Cover
2
4
3
5
7
6
1
Note: Under no circumstances shall the Lightning Detection Sensor, Chaney Instrument Co.
or the Primex Family of Companies be held responsible for any damages whatsoever that may
result from the use of or inability to use this product, including without limitation any indirect,
incidental, special, exemplary or consequential damages, which are expressly disclaimed. This
disclaimer of liability applies to any damages or injury caused by any failure of performance,
error, omission, inaccuracy, interruption, deletion, defect, delay in operation or transmission
software virus, communication failure, theft or destruction or unauthorized access to, alteration
of, or use of the product, whether for breach of contract, tortuous behavior (including, without
limitation, strict liability), negligence, or under any other cause of action, to the fullest extent
permissible by law. This does not affect any statutory rights which may not be disclaimed. The
contents of this product, including all lightning and weather data are provided “as is” and
without warranty or condition of any kind, express or implied, including, without limitation, any
warranty of merchantability or fitness for a particular purpose. Chaney Instrument Co. & the
Primex Family of Companies do not warrant that this product or the data that it provides will be
free of errors, interruptions, viruses or other harmful components. Chaney Instrument Co. & the
Primex Family of Companies do not warrant the accuracy or reliability of any lightning strike
alerts, weather data or other information provided by the product. Chaney Instrument Co. & the
Primex Family of Companies reserve the right to alter the product or withdraw it from the market
at its sole discretion.

2
Sensor Setup
Set the A-B-C Switch
The A-B-C switch is located inside the
battery compartment. Slide to set the
channel to A, B or C.
NOTE: If being used with a companion
product that has an A-B-C channel,
you must select the same letter choice
for both the sensor and the product it is
being paired with in order for the units to
synchronize.
Install or Replace Batteries
AcuRite recommends high quality alkaline
or lithium batteries in the wireless sensor
for the best product performance. Heavy
duty or rechargeable batteries are not
recommended.
The sensor requires lithium batteries in low
temperature conditions. Cold temperatures
can cause alkaline batteries to function
improperly. Use lithium batteries in the
sensor for temperatures below -4ºF /
-20ºC.
1. Slide off the battery compartment cover.
2. Insert 4 x AA batteries into the battery
compartment, as shown. Follow the
polarity (+/-) diagram in the battery
compartment.
3. Replace the battery cover.
SETUP
2Install Batteries
4 AA batteries
1A-B-C Switch
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an
extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only
batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak.
DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit
the supply terminals.
1
2
A B C

3
Placement for Maximum Accuracy
AcuRite sensors are sensitive to surrounding environmental conditions. Proper placement of
the sensor is critical to the accuracy and performance of this product.
Sensor Placement
Sensor must be placed outside to observe outdoor conditions. Sensor is water
resistant and is designed for general outdoor use, however, to extend its life
place the sensor in an area protected from direct weather elements.
Hang the sensor using the integrated hanger, or by using string (not included)
to hang it from a suitable location, like a well covered tree branch. The best
location is 4 to 8 feet above the ground with permanent shade and plenty of
fresh air to circulate around the sensor.
Important Placement Guidelines
• Sensor must be within 330 feet (100 meters) of a companion unit
(sold separately).
MAXIMIZE WIRELESS RANGE
Place unit away from large metallic items, thick walls, metal surfaces, or other objects that
may limit wireless communication.
PREVENT WIRELESS INTERFERENCE
Place unit at least 3 feet (90 cm) away from electronic devices (TV, computer, microwave,
radio, etc.).
LOCATE AWAY FROM HEAT SOURCES
To ensure accurate temperature measurement, place sensor out of direct sunlight and away
from any heat sources.
LOCATE AWAY FROM HUMIDITY SOURCES
To ensure accurate humidity measurement, locate sensor away from humidity sources.
Avoid installing the sensor near indoor pools, spas, or other bodies of water. Water sources
may impact humidity accuracy.
Lightning Detection
The sensor detects cloud-to-cloud, cloud-to-ground and intra-cloud lightning. When
lightning is detected, the sensor will beep and the strike indicator will flash for each of the
first 10 strikes. After 10 strikes, the sensor will enter silent mode but will continue to flash.
The sensor will stay in silent mode for 2 hours after the last lightning detection.

4
False Detection
This sensor features advanced technology to distinguish between lightning strikes and
interference, however in rare cases the sensor may "false detect" lightning activity due to
interference. In these situations, verify there is no lightning in the area and then relocate
the sensor. If the false detections persist, identify and relocate the source of interference or
relocate the sensor.
Interference
The sensor features enhanced interference rejection capabilities to prevent false lightning
detection. When the sensor cannot detect lightning due to interference from nearby
equipment, the sensor's interference indicator will flash.
• Electric motors (windshield wiper motor or fan motors in cars, hard drive and
optical drive motors on your PC and AV equipment, well pumps, sump pumps)
• CRT monitors (PC monitors, TV's)
• Fluorescent light fixtures (turned off or on)
• Microwave ovens (while in use)
• PC's and mobile phones
WARNING: Take shelter IMMEDIATELY when lightning is present, whether or not it has
been detected by the Lightning Detection Sensor. If you are concerned about lightning
strikes, follow all safety precautions to keep yourself and others safe. DO NOT rely on
this Lightning Detection Sensor as your only source for warnings about potentially deadly
lightning strikes or other severe weather conditions.
Problem Possible Solution
Interference
Indicator is ashing
• Relocate the sensor.
• Make sure the sensor is placed at least 3 feet (.9 m)
away from electronics that may cause interference (see
Interference section above).
Troubleshooting
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.acurite.com/support.

5
Care & Maintenance
Clean with a soft, damp cloth. Do not use caustic cleaners or abrasives.
Specications
LIGHTNING DETECTION RANGE 1 - 25 miles / 1.6 - 40km
TEMPERATURE RANGE -40ºF to 158ºF; -40ºC to 70ºC
HUMIDITY RANGE 1% to 99% RH (relative humidity)
POWER 4 x AA alkaline batteries or lithium batteries
WIRELESS RANGE 330 ft/100m depending on home
construction materials
OPERATING FREQUENCY 433 MHz
FCC Information
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications
could void the user authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.

6
Customer Support
AcuRite customer support is committed to providing you with best-in-class service. For
assistance, please have the model number of this product available and contact us in any
of the following ways:
Chat with our support team at www.acurite.com/support
Email us at [email protected]
► Installation Videos
► Instruction Manuals
► Replacement Parts
PRODUCT REGISTRATION
Register online to receive 1-year warranty protection
www.acurite.com/product-registration
IMPORTANT PRODUCT MUST BE REGISTERED
TO RECEIVE WARRANTY SERVICE
AcuRite is a wholly owned subsidiary of Chaney Instrument
Company. For purchases of AcuRite products, AcuRite provides the
benefits and services set forth herein.
For purchases of Chaney products, Chaney provides the benefits
and services set forth herein. We warrant that all products we
manufacture under this warranty are of good material and
workmanship and, when properly installed and operated, will be
free of defects for a period of one year from the date of purchase.
Any product which, under normal use and service, is proven to
breach the warranty contained herein within ONE YEAR from
date of sale will, upon examination by us, and at our sole option,
be repaired or replaced by us. Transportation costs and charges
for returned goods shall be paid for by the purchaser. We hereby
disclaim all responsibility for such transportation costs and charges.
This warranty will not be breached, and we will give no credit for
products which have received normal wear and tear not affecting
the functionality of the product, been damaged (including by acts
of nature), tampered, abused, improperly installed, or repaired or
altered by others than our authorized representatives.
Remedy for breach of this warranty is limited to repair or
replacement of the defective item(s). If we determine that repair
or replacement is not feasible, we may, at our option, refund the
amount of the original purchase price.
THE ABOVE-DESCRIBED WARRANTY IS THE SOLE WARRANTY
FOR THE PRODUCTS AND IS EXPRESSLY IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED. ALL OTHER WARRANTIES
OTHER THAN THE EXPRESS WARRANTY SET FORTH HEREIN
ARE HEREBY EXPRESSLY DISCLAIMED, INCLUDING WITHOUT
LIMITATION THE IMPLIED WARRANTY OF MERCHANTABILITY
AND THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR
PURPOSE.
We expressly disclaim all liability for special, consequential, or
incidental damages, whether arising in tort or by contract from any
breach of this warranty. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you.
We further disclaim liability from personal injury relating to
its products to the extent permitted by law. By acceptance of
any of our products, the purchaser assumes all liability for the
consequences arising from their use or misuse. No person, firm
or corporation is authorized to bind us to any other obligation or
liability in connection with the sale of our products. Furthermore,
no person, firm or corporation is authorized to modify or waive the
terms of this warranty unless done in writing and signed by a duly
authorized agent of ours.
In no case shall our liability for any claim relating to our products,
your purchase or your use thereof, exceed the original purchase
price paid for the product.
Applicability of Policy
This Return, Refund, and Warranty Policy applies only to purchases
made in the United States and Canada. For purchases made in a
country other than the United States or Canada, please consult
the policies applicable to the country in which you made your
purchase. Additionally, this Policy applies only to the original
purchaser of our products. We do cannot and do not offer any
return, refund, or warranty services if you buy products used or
from resale sites such as eBay or Craigslist.
Governing Law
This Return, Refund, and Warranty Policy is governed by the laws of
the United States and the State of Wisconsin. Any dispute relating to
this Policy shall be brought exclusively in the federal or State courts
having jurisdiction in Walworth County, Wisconsin; and purchaser
consents to jurisdiction within the State of Wisconsin.
Limited 1-Year Warranty

7

© Chaney Instrument Co. All rights reserved. AcuRite is a registered trademark
of the Chaney Instrument Co., Lake Geneva, WI 53147. All other trademarks and
copyrights are the property of their respective owners. AcuRite uses patented
technology. Visit www.acurite.com/patents for details.
Printed in China
06045 INST 080621
www.AcuRite.com