Channel Vision Central C-0501 User manual

C-0501
Network Hub Distribution Module
Termination blocks for the CAT-5 cables, Ethernet hubs/routers. Bring the internet
DSL/CATV modems to any room in the home, or create a home data network.
Installation Instructions:
234 FISCHER AVENUE zCOSTA MESA, CA 92626
[phone] z(800) 840-0288 z(714) 424-6510 FAX
HTTP://WWW.CHANNELVISION.COM zE-MAIL: [e-mail]
Channel Vision
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or workmanship which occur during normal use of
this product with new or rebuilt parts, free of charge in the USA, for two years from the date of original purchase. This is a
no hassle warranty with no mail in warranty card needed. This warranty does not cover damages in shipment, failures
caused by other products not supplied by Channel Vision Technology, or failures due to accident, misuse, abuse, or
alteration of the equipment. This warranty is extended only to the original purchaser, and a purchase receipt, invoice, or
other proof of original purchase date will be required before warranty repairs are provided.
Mail in service can be obtained during the warranty period by calling [phone] toll free. A return Authorization number
must be obtained in advance and can be marked on the outside of the shipping carton.
This warranty gives you specific legal rights, and you may have other rights (which vary from state to state). If a problem with
this product develops during, or after, the warranty period, please contact Channel Vision, your dealer, or any factory-
authorized service center.
Installation Instructions:
Step 1: Install 8 Cat 5 cables to 8 wallplate locations.
Step 2: Use 110 tool (J-110) or (1017) to punch down 8 locations on C-0501
Module.
Step 3: Connect (C-0409-3’) or (C-0408-01’) interconnects from C-0501
Module to Hub, or Router to Hub, depending on system
requirements.
© 2002, CHANNEL VISION™

The C-0501 terminates
data lines with CAT-5
termination (RJ-45).
Use CAT-5 cables to
homerun services to
wall plates in the
desired location.
A router to a hub can
be added for CATV
modems to create 8
individual location in
the home or office to
avoid IP addresses.
12345678 12345678 123456 123456
8-position 6-position
Modular cords wired to the T568A color scheme on both ends are
compatible with T568B system and vice versa.
T568A/T568B USOC USOC DEC
white/blue-blue
white/orange-orange
white/green-green
white/brown-brown
UTP Horizontal Cable (solid 24 AWG)
Modular Plug Pair Configurations:
It is important that the pairing of wires in the modular plug match
the pairs in the modular jack as well as the horizontal and back-
bone wiring.If they do not,the data being transmitted may be
paired with incompatible signals.
CHANNEL VISION'S connector part # for (RJ-45) J-C3AW 8
Pin Part # for (RJ-11) J-66-C3-6 Pin
Untwist no more than .5''
Keep unsheathed wire short
STANDARD TERMINATION
FOR 110 PUNCHDOWN
brown brown/white
green
green/white
orange
orange/white
blue
blue/white
The 110 is a sophisticated
insulation displacement connection
system.To push the wire between
the contact blades,use only a 110
punch down tool.Using any tool
other than a 110 punch tool may
not seat the wire properly and can
damage the contacts.
8 Port Hub
C-0501
CHANNEL VISION
Central
DATA
To data jacks in 8 wall
plates. Please refer to
Channel Vision (J) series
wallplate products.