Channel Vision 5040 User manual

5040
IR Illuminator
By
8

2
Features:
Allows standard cameras to see at night
h
Waterproof and suitable for outdoor use
h
Built-in light sensor activates 24 piece LED IR illuminator
h
View images 33 feet away in total darkness
h
Easy to install
h
Warnings:
Do not look directly into the illuminator when in use.
h
Do not touch the body of the unit when in use. It can
h
reach temperatures as high as 150ºF.
Do not point the illuminator directly at paper or flammable
h
materials.
Avoid touching the lens with fingers. Clean off any finger
h
prints with cleaning alcohol and cotton swabs.
The 5040 is a standalone IR illuminator that can be used to
add night vision capabilities to standard CCTV cameras. Its
special power adaptor cable allows it to be added to existing
camera installations without the need for new wires. This
simple and effective product is a great way to add value to
any camera installation.
IR Illuminator
Mounting Bracket Power Supply Power Wire Adaptor
Screws, Washers,
& Dust Covers

3
Model 5040
Installation
Option 1:
(This option is only valid for cameras using 12VDC power.)
Install a standard CCTV camera as shown. Make sure the
h
power supply can supply enough current for both the
camera and the illuminator.
Use the power wire adaptor to split the power supply output
h
so it can feed both the camera and the illuminator.
Mount the illuminator as shown and connect the power wire
h
adaptor.
Point the illuminator at the desired area.
h
Option 2:
Mount the illuminator as shown and connect the power
h
supply.
Point the illuminator at the desired area.
h
2-Conductor power
supply extension
(not included)
Power Wire Adaptor
(included)
Option 1: Shared Power Supply Option 2: Separate Power Supply
Crimp-on splice
connectors
(not included)
To Monitor
or
Video distribution Power supply
(included)
Power supply
(included)
Coax extension
(not included)
BNC connector
Standard CCTV Camera
Typical current draw is
150mA or less
5040
Max current draw is
200mA
5040

500-213 Rev B
*Specifications:
Wave Length: 850nm
Projection Angle: 70º
Projection Distance: Up to 33 feet (10 meters)
LED Life: 6000 hours
Auto Power On/Off: CDS auto control
Filter: Tempered Glass
Power Requirements: 12VDC
Power Consumption: 200mA (max)
Infrared Illumination: 24 IR LEDs
Dimensions: 2.09” Dia. x 1.46” Long (53mm x 37mm) Body Only
Operating Temp: -10°C to 60°C (14°F to 140°F)
*Specifications subject to change without notice.
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or
workmanship which occurs during normal use of this product with new or rebuilt
parts, free of charge in the USA, for two years from the date of original purchase. This
is a no hassle warranty with no mail in warranty card needed. This warranty does not
cover damages in shipment, failures caused by other products not supplied by
Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration
of the equipment. This warranty is extended only to the original purchaser, and a
purchase receipt, invoice, or other proof of original purchase date will be required
before warranty repairs are provided.
Mail in service can be obtained during the warranty period by calling [phone]
toll free. A Return Authorization number must be obtained in advance and can be
marked on the outside of the shipping carton.
This warranty gives you specific legal rights and you may have other rights (which
vary from state to state). If a problem with this product develops during or after the
warranty period, please contact Channel Vision Technology, your dealer or any
factory-authorized service center.