Charge Amps Beam User manual

Charge Amps Beam
User Manual

© 2021 Charge Amps AB
User manual for
Charge Amps Beam
Doc. Nr: 13017
2
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
2
Contents
Safety precautions ........................................................................................ 3
Warning ............................................................................................................. 3
Use ................................................................................................................. 4
To start charging .............................................................................................. 4
Storage .............................................................................................................. 5
General instructions ......................................................................................... 5
Maintenance ..................................................................................................... 5
Precautions ....................................................................................................... 6
Troubleshooting ............................................................................................... 6
Rights .............................................................................................................. 7

© 2021 Charge Amps AB
User manual for
Charge Amps Beam
Doc. Nr: 13017
2
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
3
Safety precautions
Read the safety precautions before use
WARNING –This manual contains important instructions for the use and maintenance of
the Beam charging cable. When using electrical products, you must always follow basic
safety precautions, including the following instructions.
WARNING –This manual contains important instructions for the use and
maintenance of the Beam charging cable. When using electrical products,
you must always follow basic safety precautions, including the following
instructions.
Contains instructions on the prevention of fire and electric shock. Make
sure you read and keep this User Manual.
WARNING – Do not use Beam for any purpose other than charging
electric vehicles.
Warning
1. Stop using Beam immediately if a fault or an abnormality occurs when charging, or
if the cable is damaged.
2. Stop using Beam if it becomes overheated.
3. Keep the plug dry, and take appropriate care when operating in wet conditions.
4. Never use Beam if any part is broken, worn, cracked, open or shows any signs of
being damaged. Contact your reseller immediately if you are uncertain if it is safe
to use your Beam.

© 2021 Charge Amps AB
User manual for
Charge Amps Beam
Doc. Nr: 13017
2
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
4
5. Not for use by children.
6. Handle Beam with care, do not drop it, and never bend it or give it a hard tug.
Use
To start charging
1. Connect Beam to a type 2 socket on a charging station. Make sure this step is
always carried out first.
2. Then connect Beam to your car.
3. Charge up
4. After charging is complete – disconnect your car first.

© 2021 Charge Amps AB
User manual for
Charge Amps Beam
Doc. Nr: 13017
2
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
5
Storage
1. If Beam is stored for a prolonged period, keep it in a cool, dark place.
2. Check and ensure that no damage has occurred the first time you use the cable
after transport.
General instructions
1. Read all the instructions before using Beam.
2. The unit must not be left unattended when used near children.
3. Never put your fingers in the sockets/connectors.
4. Do not immerse Beam in water or other fluids.
Maintenance
1. Do not try to take the cable apart or repair it. Contact your reseller if you think
your cable needs to be repaired.

© 2021 Charge Amps AB
User manual for
Charge Amps Beam
Doc. Nr: 13017
2
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
6
2. Although the cable is water resistant, only use a damp cloth and mild detergent
when cleaning your Beam. Keep the connector’s connection surfaces (metal pins
and sleeves) dry when cleaning.
Precautions
1. Never connect Beam to a damaged or defective charging station.
2. Some charging stations lock the cable in place. When you have finished charging,
always disconnect the vehicle first and then the charging station.
3. Prevent foreign bodies or materials from entering Beam’s connectors.
4. Avoid stepping on, driving over or placing heavy objects on Beam.
Troubleshooting
If charging does not start, carry out the following steps:
1. Make sure Beam is connected correctly to the charging station’s charging socket.
2. Make sure Beam is connected correctly to the vehicle’s charging socket.
3. If neither of the above works, disconnect the connectors at both ends and check
whether any dirt or foreign bodies have got stuck in the connector. Contact your
reseller or email [e-mail] if the problem persists.

© 2021 Charge Amps AB
User manual for
Charge Amps Beam
Doc. Nr: 13017
2
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
7
Rights
The information in this document has been checked for accuracy. Charge Amps AB
reserves the right to make technical changes and changes to the contents of the
document without prior notice. Charge Amps AB can therefore not guarantee that all of
the contents of this particular document are accurate, up-to-date, and free from printing
and proofreading errors. Moreover, Charge Amps AB cannot be held liable for any
mistakes, near-misses, injuries/damage or incidents – direct or indirect – that can be
linked to the use of the instructions or products in this document.
Charge Amps AB reserves all rights to this document, as well as the information and
illustrations therein. It is strictly forbidden to – in whole or in part – copy, adapt or
translate the information without prior written permission from Charge Amps AB.
© Copyright 2021 Charge Amps AB. All rights reserved.