Checkpoint 4800 User manual

.
P/N: 704783 | P. 1
© 2011 Check Point Software Technologies Ltd. All rights reserved.
For a list of our trademarks, please refer to: http://www.checkpoint.com/copyright.html.
For a list of our Third Party Copyright notices, please refer to: http://www.checkpoint.com/3rd_party_copyright.html.
Replacing Check Point 4800
Power Supply
Important - Make certain that you are electromagnetically grounded when
performing the following procedures. Static electricity can damage the appliance.
Item
Description
1
Power supply unit
2
Extraction handle
3
Release lever
4
Power cord socket
5
Power switch

P. 2
Removing Power Supplies
To remove a power supply unit:
1. If the alarm sounds, press the red alarm button to the right of the power supply.
The alarm stops.
2. Remove the power cord from the power supply unit.
3. Engage and hold the release lever on the power supply or placeholder unit.
4. Pull the extraction handle to remove the power supply or placeholder unit.
Note - Remove the power supply unit with the extraction handle to
prevent any possible damage.
Installing Power Supplies
To install a replacement power supply:
1. Insert the power supply or placeholder unit into the power supply slot.
2. Push the power supply or placeholder unit until the release lever clicks.
3. Insert the power cord into the power supply socket. Make sure that the green LED is
illuminated.