Childcare 091203 User manual

Accessory
IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY
Safety precaution...
Read all instructions before use of the Accessory Cot Bed Rail. Keep instructions for future use.
Check what you have received...
You have received 1 box.Please check the contents of the box against the list below. If anything is missing,please contact Customer
Service. In Australia,contact CNP Brands on 1300 667 137,in New Zealand contact Wainhouse Distribution on 0800 567 5000.
Accessory
Cot Bed Rail
MODEL # 091203
Accessory Bed Rail x 1
# 091203 Long Bolts x 4
Barrel Nuts x 4
THETODDLER BED IS ONLY DESIGNED FOR USE WHENTHE CHILD CAN GET ON AND OFFTHE BED
UNAIDED,AT APPROXIMATELY 2-5YEARS OF AGE.
THE COT BED RAIL ARE ONLY DESIGNED FOR USE WITH CHILDCARE COTS AND WITH A CHILDCARE
MATTRESS WHICH HAS THE FOLLOWING DIMENSIONS:(1300MM LONG X 690MM WIDE X 100-
150MMTHICK).
THIS BED RAIL DOES NOT PROVIDE PROTECTION AGAINST FALLS,A SEPARATE BED GUARD IS
RECOMMENDED SHOULDTHIS BE REQUIRED.
WARNING
Supplied loose in box...

Accessory
IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY
Accessory
Cot Bed Rail
MODEL # 091203
How to care for your Childcare Accessory Cot Bed Rail
Maintenance
Always check parts regularly for tightness of screws, nuts and other fasteners – tighten or replace if
required.To maintain the safety of your Accessory Cot Bed Rail seek prompt repairs for bent,torn,worn
or broken parts. Use only those parts and accessories approved by CNP Brands.
Distributed in Australia by CNP Brands
20 Calarco Drive,
Derrimut,VIC, 3030
Customer Service 1300 667 137
W: www.cnpbrands.com.au
E: [e-mail]
F: www.facebook.com/CNPBrands
I: @cnp_baby
Distributed in New Zealand by Wainhouse Distribution
2-6 Argyle St, Morningside,
PO Box 41-014,
St Lukes,Auckland, New Zealand
Customer Service: 0800 567 5000
E: [email protected].nz
Assembly Instructions...
3
5
4
6
Remove Drop Side Panel
by pushing the End Panel
outwards while sliding the pin
from the lower track rst and
then the top pin.
Repeat for the other End
Panel.
Position Bed Rail (smooth side
out) between the End Panels
and insert the long bolts
through the End Panels.
When all bolts are partially
tightened,nish with Allen key
until rm.
Insert four Barrel Nuts into
the holes on the side of the
Bed Rail with the slot facing
the end of the Bed rail (see
below).
Re-tighten the Mattress base
bolts.
Your Toddler Bed is ready for
use.
3a.
3b.
5a.
5b.
4a.
6a.
6b.
1 2
Remove two ller bolts and
blanks from End Panel.
Repeat for the other End
Panel.
Loosen Mattress base bolts
but do not remove.
1a.
1b.
2a.