Dog Shock Collar lJser's
Manual
(static imPulse +vibratione)
Thank you for choosing oru product!
Pleaseread this manual carefully before using the product'
Pleasebe reminded that upon installing batteries in the receiver, you should tnmediately
press the remote controller for three seconds, so asto match the remote controller and the receiver'
Flease do read the Cautions, for fear that unwanted results arise from improper operation'
I. Preparation before using
1.Make sure that batteries are installed in the remote controller and the receir-er'
2. The remote controller and the receir.er of this set are automatically matched. When batteries are installed in the
receiver, the receiver v.ill make a sound. At that time you should press any button on the remote controller and the
receiver will give three successive sounds. tn this way the match is tlone and the remote control system can operate
normally.
3. If the receiver doesn,t give a sound when batteries are installed, please take out the batteries for more ten seconds
and put them back and try again.
4. Checking the remote controller: Pressthe buttons on the remote controller one by one and the indicator light wiX light'
If the indicator light doesn't ]ight or goesclim,change the batteries. The battery celt of the remote conholler is magnetic'
for turning on the power of the receiver'
b. Checking the receiver: The nagnetic incluction power switch being instalted in the remote controller, when move tlte
magnetic part of the remote controller close to the indicator light side of the receiver the indicator light will light'
' *l"irng jh" po*", is turned( oN)- Another closing up?rf this will turn off thelpower while the indicdtorligttt-goes
(oFr)
6. when batteries are first installed in the receiver, the circuit will be automatically turned on. After it is closed by ma€fietic
force, it can be open by magnetic force too. If the batteries are taken out and reinstalled, the circuit will be turned on'
7.Adjust the length of the collar to fit the neck of the pet. The proper tightness should be that you can insert a finger in
bel.ween.
g. Respectively press the shock buttons or vibration buttons on the remote controller and the receiver will make static
impulse or vibration.
9. press the sound button on the remote controner and both the remote controller and the receiver will make the "B-B"
sound. There is a three-grade adjustment switch on the side of the remote controller for adjusting the volume of the
,,B-B,,sound of the remote controller. The three grades are l,oud / Low / Stop. You can train the pet to take your orders
by dift'erent tempos. Every order must have a fixed tempo. An insisting training will bring you a wonderftrl effect' For
example, three "B-B" sounds ntean "coming back"'
l0.press the Light button on the remote controller, red laser patterns will be given from the front of the remote controller
and the receiver will give flashes of light at the same tine. The red laser patterns is for the fun of the pet, while the
light from the receiver helps you to look for your dog at night'
ll.The static impulse of the collar is to curb the improper deeds of the pet. Aftei'each successful check, you stiodd let
the pet know what should be done and what should not be done. After.anumber of trainings the pet will understand
what you like and don't like.
l2.prepare some socks for the dog asrewards for good deeds. This will make better effect inthe training'
II. Operational instruetions:
1.Turn the switch of the remote controller to the "oN" posilion. Turn it "oFF" if you don't use it, for fear of mistaken
operation.
2. open the insert buckle of the collar and put the collar round the neck of the pet. Adjust the tightrnessof collar that you
can insert a finger in between.
3. Most pets feel uncomfortable at first wearing the collar. Don't use the shock function at that time until Yotiale sure
that the pet has gotten used to the collar. The static impulse is useil to curb the improper deeds of the pet. Doir't use
it casually or to make fun of the pet' :
4. you can call your dog soundlessly by,' vibration" in a long distance. You can dLlso
use the.'lB-B" sound to convey your
orders.
b.The B-B sound of the remote controller can be a{usted by the pushrod switch on the sidb: Loud / Low / Silent'
6. Flashes of light will make it easyfor you to look for your dog at night. The Iaser patterns will provide fim for the pet'
7.Youcantirmoffortumonthepowerofthereceive.!.v!trmagnqticpartoftheremotecontroller.
g.If you don,t use this product, take the collar antl receiGr off tt.r"pet and tu-rnoff the fower, so asto'prolong the lifetime
of the baLteries.
9.If you don't use the collar receiver for a long time, take out the batteries.
