CipherLab CPT-720 User manual

Your CipherLab CPT-720 Cradle was designed to enable the discharging and charging of battery packs
used in conjunction with the CPT-720 portable terminal; to communicate with a Host computer via RS-232;
and to communicate with other CPT-720 Cradles via RS-485.
Packing List
This package includes the following:
1. Cradle
2. AC Adaptor
3. RS-232 cable
4. Pack of wall mount screws
Specifications
Power supply: 12V DC
Dimensions: 112mm (L) x 125mm (W) x 132mm (H)
Storage temperature: -10 ~ 60 C
Operating temperature: 0 ~ 50 C
Charging current: 250 mA.
Installation
1. Connecting the power
Insert the AC adaptor into the outlet and connect its DC jack
to the Cradle. (Fig. 1)
2. Stand alone, connect the Cradle to Host computer with the
supplied RS-232 cable. (Fig. 2)
3. Multi-drop connection, connect the Cradle to Host computer
with the supplied RS-232 cable. Then connect every unit
directly to the previous unit. Up to 32 units can be connected
together. Note that each cradle should use its own power
supply. (Fig3)
Operation
The names of parts and their functions (Fig. 4)
A. Chargesthe battery within the Terminal
<Fig.2>
<Fig.1>
<Fig.3>
A
E
C
B
D
<Fig.4>
F

B. Chargesthe spare battery pack
C. Discharge button (will discharge then charge the Terminal battery)
D. RS-232 port for transmission to host Computer
E. RS-485 port for connection and transmission between cradles
F. LCD Charging Status Display:
25% = 25 –49% charged battery
50% = 50 –74% Charged battery
75% = 75% - 99% Charged battery
100% = Fully Charged.
Cautions
1. Use only specified rechargeable batteries.
2. Do NOT charge disposable batteries, terminal or cradle may be
damaged.
3. Do NOT discharge the batteries whilst transmitting data.
4. Do NOT use or store this unit in a humid or dusty place.
5. Keep unit in a dry place
6. When not in use, please remove the AC adaptor from the wall
outlet.
Note
After inserting the rechargeable battery into the spare battery
charging slot, the cradle will charge the battery until full charge
is reached. (Fig. 5)
However, if you load a fully charged battery into the CPT-720
and insert the unit into the Main Terminal charging slot, the LCD
may show only 75% full initially. (Fig. 6)
This is normal as the voltage level of a charged battery will drop
from peak level and stabilize at a level lower than full charge.
The charging circuitry will take up to 30 minutes before the LCD
shows 100%.
(Fig. 7)
Syntech Information Co., Ltd. - 8F, No.210 Ta-Tung Road, Sec3, His-Chih, Taipei Hsien, Taiwan
Tel: [phone] - Fax : [phone] - http://www.cipherlab.com.tw
<Fig. 5>
<Fig. 6>
<Fig.7>