CipherLab 8500 Series User manual

www.cipherlab.com Copyright 2007 CipherLab Co., Ltd.
8500 Vehicle Cradle & Travel Charger
Travel Charger
Vehicle Cradle,
is suitable for use in your vehicle
when you are always on the road.
in conjunction with the mounting kit,
Making charging convenient and flexible,
Travel Charger is a good traveling companion
for your 8500 Mobile Computer.
U
n
i
v
e
r
s
a
l
B
a
ll
&
S
o
c
k
e
t
M
o
u
n
t
i
n
g
K
i
t
Step 1 - Align the holes of the round plate on the cradle to those of the mount base.
Insert bolts through these matching holes.
Screw nuts onto bolts to tighten the joint of the cradle and mount base.
Step 2 - Screw the mount base on the other end to a suitable place in your vehicle.
Step 3 - Adjust the mounting angle by rotating the two ends of the mounting kit.
Step 4 - Hold 8500 firmly and insert it head-first to the adjustable bracket at a proper angle.
Step 5 - Hold 8500 against the adjustable bracket and move it upwards until 8500 can sit in the cradle.
Press and slide out.
Slide along matching grooves
until 8500 snaps into its place.
Serial Port
Power receptacle

www.cipherlab.com DOCVersion 2.00
8500 Vehicle Cradle & Travel Charger
A
B
(W) 82 mm x (H) 58.8 mm x (D) 32 mm
(W) 154 mm x (H) 262 mm x (D) 94 mm
Serial port, DB-9 female connector
IR port, software programmable -
38,400 bps (default); 115,200 bps (Max.)
Output - DC 6V / 3.3A / Input - AC 110/220 V
Output - DC 6V / 2.5A / Input - DC 12 ~ 48 V
15 kV air discharge / 8 kV direct discharge
CE, FCC, IC, C-Tick(MIC for Travel Charger only)
Operating -20C~80C/Storage -30C~90C
Operating 10% ~ 90% / Storage 5% ~ 95%
Physical Characteristics
Electrical Characteristics
Environmental Characteristics
Dimensions for Travel Charger
for Vehicle Cradle
Communication Ports
Operating Power
for Travel Charger
for Vehicle Cradle
Electrostatic Discharge
EMC Regulation
Temperature
Humidity (non-condensing)
Connecting toYour Laptop
Charging from the Cigarette Lighter
Charging from a 12 Volt DC Power Source
Use the serial cable to connect Vehicle Cradle or Travel Charger to a computer.
You may purchase the USB Virtual COM cable (part # 308) to connect to the
USB port on your computer.
Step 1. Connect the charging cable to the power receptacle at the back of
Vehicle Cradle.
Step 2. Connect the charging cable to the vehicle’s lighter socket.
Same as above except for connecting the cable assembly (with in-line fuse holder
pre-installed) directly to a +12V DC power source instead of the lighter socket.
Follow these instructions.
Step 1. Connect the black wire to the vehicle’s ground wire.
Step 2. Install the fuse holder to the red wire and connect it to a +12V DC
power source.
For safety concerns, always remove the charging cable from power source when
not in use for a long period of time.
Warning
Only a qualified technician can perform the car kit power connection.
Improper connection may cause damage to the product or vehicle.
a
b
ab
Aa
Ba
RS-232
-
+
DC 12V-48V
Cable Assembly
with in-line fuse holder (3A) pre-installed