Cirrus Screens Arcus G3 User manual

Arcus G3
X8
X2
X2
X8
X6

to
s

2
Installation
According to the surface of installation, choose the appropriate screws
needed for mounting(Use Mounting Screws for wood surfaces,use Mounting
Screws and Concrete Anchors for conrete surfaces). It has four installation
ways for the screen, choose the installation way that works for you.

Installation
3

4
Installation

5

6

Adjusting the screen length limits
We only recommend the experienced AV installer to undertake below procedures:
Downwards
Ensure that the screen is in the CLOSED
Stand in reach of the screen while holding the RF remote.
Press the DOWN button of the RF remote, when the screen goes down about to the desired
position, press the adjustment button.
Press the adjustment button repeatedly until the screen reaches the desired position.
Press the UP button of the RF remote to save the settings.
Upwards
Ensure that the screen is in the OPENED
Stand in reach of the screen while holding the RF remote.
Press the UP button of the RF remote, when the screen goes up about to the desired position,
press the adjustment button.
Press the adjustment button repeatedly until the screen reaches the desired position.
Press the DOWN button of the RF remote to save the settings.
CAUTION: To avoid the bottom bar from going too far into the casing, please follow
Motor Limit Adjustment Button
Please remove the grommet before making the adjustment.
the above procedures with strict accordance.
It is the responsibility of the installer to verify drop and retraction limit
controls. We only recommend that experienced AV installers adjust the
motor limits of the projection screen.
The upper limit should never be adjusted - it controls the point at which the
screen stops retracting into the case and is factory-set to flush.
Improperly adjusting the limits of the motor will cause damage to the
screen and motor and will void all warranty.