Cisco Catalyst 4500 Series User manual

Americas Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: [phone]
800 553-NETS (6387)
Fax: [phone]
Catalyst 4500 Series Switch Cisco IOS
Software Configuration Guide
Release IOS XE 3.9.xE and IOS 15.2(5)Ex

THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL
STATEMENTS, INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT
WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.
THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT
SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE
OR LIMITED WARRANTY, CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.
The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB’s public
domain version of the UNIX operating system. All rights reserved. Copyright © 1981, Regents of the University of California.
NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED “AS IS” WITH
ALL FAULTS. CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT
LIMITATION, THOSE OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF
DEALING, USAGE, OR TRADE PRACTICE.
IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING,
WITHOUT LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO
OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this
URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply
a partnership relationship between Cisco and any other company. (1110R)
Catalyst 4500 Series Switch Cisco IOS Command Reference
Copyright © 1999–2016 Cisco Systems, Inc. All rights reserved.

iii
Catalyst 4500 Series Switch Cisco IOS Command Reference—Cisco IOS XE 3.9.0E and IOS 15.2(5)Ex
Catalyst 4500 Series IOS
Commands
New Commands
auto security
auto security-port
show auto security
Revised Commands
A Commands
aaa accounting dot1x default start-stop group radius
aaa accounting system default start-stop group radiusclear mac-address-table
access-group mode
access-list hardware capture mode
access-list hardware entries
access-list hardware region
action
apply
ancp client server
ancp mode client
apply
arp access-list
attach module
authentication control-direction
authentication critical recovery delay
authentication event
authentication fallback
authentication host-mode

iv
Catalyst 4500 Series Switch Cisco IOS Command Reference—Cisco IOS XE 3.9.0E and IOS 15.2(5)Ex
authentication open
authentication order
authentication periodic
authentication port-control
authentication priority
authentication timer
authentication violation
auto qos classify
auto qos classify police
auto qos srnd4
auto qos trust
auto qos video
auto qos voip
auto qos voip cisco-softphone
auto security
auto security-port
auto-sync
average-packet-size (netflow-lite monitor submode)
C Commands
call-home (global configuration)
call-home request
call-home send
call-home send alert-group
call-home test
channel-group
channel-protocol
cisp enable
class-map
clear counters
clear errdisable interface
clear hw-module slot password
clear interface gigabitethernet
clear interface vlan
clear ip access-template
clear ip arp inspection log
clear ip arp inspection statistics

v
Catalyst 4500 Series Switch Cisco IOS Command Reference—Cisco IOS XE 3.9.0E and IOS 15.2(5)Ex
clear ip dhcp snooping binding
clear ip dhcp snooping database
clear ip dhcp snooping database statistics
clear ip igmp group
clear ip mfib counters
clear ip mfib fastdrop
clear ip wccp
clear lacp counters
clear netflow-lite exporter statistics
clear netflow-lite monitor statistics interface
clear nmsp statistics
clear mac-address-table dynamic
clear pagp
clear port-security
clear pppoe intermediate-agent statistics
clear qos
clear switch virtual dual-active fast-hello
clear vlan counters
clear vmps statistics
control-plane
cos (netflow-lite exporter submode)
counter
D Commands
debug adjacency
debug backup
debug condition interface
debug condition standby
debug condition vlan
debug device-sensor
debug dot1x
debug etherchnl
debug interface
debug ip dhcp snooping event
debug ip dhcp snooping packet
debug ip verify source packet
debug ipc

vi
Catalyst 4500 Series Switch Cisco IOS Command Reference—Cisco IOS XE 3.9.0E and IOS 15.2(5)Ex
debug lacp
debug monitor
debug nmsp
debug nvram
debug pagp
debug platform packet protocol lacp
debug platform packet protocol pagp
debug pm
debug port-security
debug pppoe intermediate-agent
debug redundancy
debug spanning-tree
debug spanning-tree backbonefast
debug spanning-tree switch
debug spanning-tree uplinkfast
debug sw-vlan
debug sw-vlan ifs
debug sw-vlan notification
debug sw-vlan vtp
debug udld
debug vqpc
define interface-range
deny
destination (netflow-lite exporter submode)
device-sensor filter-list
device-sensor filter-list dhcp
device-sensor filter-spec
device-sensor notify
diagnostic fpga soft-error recover
diagnostic monitor action
diagnostic start
dot1x auth-fail max-attempts
dot1x auth-fail vlan
dot1x credentials (global configuration)
dot1x critical
dot1x critical eapol
dot1x critical recovery delay
dot1x critical vlan

vii
Catalyst 4500 Series Switch Cisco IOS Command Reference—Cisco IOS XE 3.9.0E and IOS 15.2(5)Ex
dot1x control-direction
dot1x guest-vlan
dot1x guest-vlan supplicant
dot1x host-mode
dot1x initialize
dot1x mac-auth-bypass
dot1x max-reauth-req
dot1x max-req
dot1x port-control
dot1x re-authenticate
dot1x re-authentication
dot1x system-auth-control
dot1x timeout
dscp (netflow-lite exporter submode)
dual-active detection (virtual switch)
duplex
dual-active recovery ip address
duplex
E Commands
erase
errdisable detect cause
errdisable recovery
export-protocol (netflow-lite exporter submode)
exporter (netflow-lite monitor submode)
F Commands
flowcontrol
H Commands
hardware statistics
hw-module beacon
hw-module module start
hw-module module stop
hw-module port-group
hw-module power
hw-module system max-port-num-mode 1/2

viii
Catalyst 4500 Series Switch Cisco IOS Command Reference—Cisco IOS XE 3.9.0E and IOS 15.2(5)Ex
hw-module system max-port-num-mode 1/2 switch 1/2/all
hw-module system max-queue-limit
hw-module uplink mode
hw-module uplink select
I Commands
instance
interface
interface (virtual switch)
interface port-channel
interface range
interface vlan
ip admission proxy http refresh-all
ip arp inspection filter vlan
ip arp inspection limit (interface)
ip arp inspection log-buffer
ip arp inspection trust
ip arp inspection validate
ip arp inspection vlan
ip arp inspection vlan logging
ip cef load-sharing algorithm
ip dhcp snooping
ip dhcp snooping binding
ip dhcp snooping database
ip dhcp snooping information option
ip dhcp snooping information option allow-untrusted
ip dhcp snooping limit rate
ip dhcp snooping trust
ip dhcp snooping vlan
ip device tracking maximum
ip igmp filter
ip igmp max-groups
ip igmp profile
ip igmp query-interval
ip igmp snooping

ix
Catalyst 4500 Series Switch Cisco IOS Command Reference—Cisco IOS XE 3.9.0E and IOS 15.2(5)Ex
ip igmp snooping report-suppression
ip igmp snooping vlan
ip igmp snooping vlan explicit-tracking
ip igmp snooping vlan immediate-leave
ip igmp snooping vlan mrouter
ip igmp snooping vlan static
ip local-proxy-arp
ip mfib fastdrop
ip name-server
ip route-cache flow
ip source binding
ip sticky-arp
ip verify header vlan all
ip verify source
ip verify unicast source reachable-via
ip wccp
ip wccp check services all
ip wccp group-listen
ip wccp redirect
p wccp redirect exclude in
ipv6 mld snooping
ipv6 mld snooping last-listener-query-count
ipv6 mld snooping last-listener-query-interval
ipv6 mld snooping listener-message-suppression
ipv6 mld snooping robustness-variable
ipv6 mld snooping tcn
ipv6 mld snooping vlan
issu abortversion
issu acceptversion
issu commitversion
redundancy config-sync mismatched-commands
issu loadversion
issu runversion
issu set rollback-timer
L Commands
l2protocol-tunnel

x
Catalyst 4500 Series Switch Cisco IOS Command Reference—Cisco IOS XE 3.9.0E and IOS 15.2(5)Ex
l2protocol-tunnel cos
l2protocol-tunnel drop-threshold
l2protocol-tunnel shutdown-threshold
lacp port-priority
lacp system-priority
license right-to-use activate
license right-to-use deactivate
lldp tlv-select power-management
logging event trunk-status global (global configuration)
logging event link-status global (global configuration)
logging event trunk-status global (global configuration)
logging event link-status global (global configuration)
logging event link-status (interface configuration)
logging event trunk-status (interface configuration)
M Commands
mac access-list extended
mac-address (virtual switch)
mac-address-table aging-time
mac-address-table dynamic group protocols
mac-address-table learning vlan
mac-address-table notification
mac-address-table static
macro apply cisco-desktop
macro apply cisco-phone
macro apply cisco-router
macro apply cisco-switch
macro auto device
macro auto execute (built-in function)
macro auto execute (remotely-defined trigger)
macro auto execute (user-defined function)
macro auto global processing
macro auto mac-address-group
macro auto monitor
macro auto processing
macro auto sticky
macro global apply cisco-global