Cisco SG300 series User manual

US OFFICE:
TEL: [phone]
FAX: [phone]
EMEA OFFICE:
TEL: + 44 (0) 1793 230 343
FAX: + 44 (0) 1793 230 583
WYRESTORM NETWORKHD
SWITCH CONFIGURATION GUIDE
NetworkHD uses the following smart features of your switch.
Multicast Video
With multicast video only one instance of the video stream is transmitted onto the network and the clients in turn grab a
copy of the video from the network. Multicast video always uses UDP at the Transport layer.
IGMP Snooping
IGMP snooping is the process of listening to Internet Group Management Protocol (IGMP) network trac. The feature
allows a network switch to listen in on the IGMP conversation between hosts and routers.
Cisco SG300 & SG500 Series Switches
1. Enable Bridge Multicast Filtering Status in
Multicast > Properties

For additional product information visit www.wyrestorm.com
For technical support contact: US: [phone] EMEA: [phone]
5. Ensure that settings are saved to the boot conguration or else
they will be lost when the switch is power cycled.
Once the conguration is saved power down the switch and
connect all the NetworkHD Tx & Rx devices.
2. Enable IGMP Snooping Status in Multicast > IGMP Snooping
3. In Multicast > IGMP Snooping select the VLAN NetworkHD is attached to and press Edit > Enable IGMP
Snooping Status, Enable IGMP Querier Status, Select IGMP Querier Version IGMPv2
4. In Multicast > Forward All > Set to Forbidden any ports that have devices connected that are not NetworkHD
components, including PC’s and third party control systems.