Citizen JN98901 User manual

Side view
Hook
Top cover
Front top cover
AUTO-CUTTER UNIT INSTALLATION GUIDE
CL-S700 Series Model JN98901/JN98911
CITIZEN is a registered trademark of CITIZEN HOLDINGS CO., Japan.
CITIZEN es una marca registrada de CITIZEN HOLDINGS CO., Japón.
Copyright © 2008 by CITIZEN SYSTEMS JAPAN CO., LTD.
Caution
This guide is provided for use by service representatives. Service representatives
install the auto-cutter unit, so notify the supplier who sold it to you.
(1) Check to make sure that the printer’s power switch is turned off then disconnect the
power cord.
(2) Open the top cover and lift the thermal printhead and sensor arm.
(3) Remove the front top cover from the top
cover. (2 screws)
Note There is a hook on the front top cover.
Be careful not to bend the hook while
removing the front top cover from the
top cover.
(4) Remove the cutter attachment cover from
the front top cover that you have removed.
Note The cutter attachment cutter that
you have removed is used to remove
the auto-cutter unit, so store it
carefully.
Thermal printhead
Head open lever Sensor arm open lever
Sensor arm
Cutter attachment cover

(5) Remove the operation panel on the front of the printer. (3 screws)
When doing this, remove the flexible cable that is connected to the operation panel.
(6) Remove the front right cover on the front of the printer. (2 screws)
(7) Remove the pulley cover (black) that is on the right front part of the printer. (1 screw)
Using nippers, cut out the notch on the pulley cover that you have removed.
Flexible cable
Notch

(8) Remove the front center cover. (2 screws)
(9) Remove the front cover from the front center cover that you have removed. (2 screws)
Note The front cover that you have
removed is used when the
auto-cutter unit has been
removed, so store it carefully.
(10) Attach the pulley cover (black) that you
removed at step 7 in its original position.
(11) Connect the connector of the auto-cutter unit to the relay printed circuit board as
shown in the figure. For JN98901, pass the cord through the hole on the right side of
the printer housing.
Note It you pass the connector through in the wrong insertion direction, it cannot be
connected. Insert it after checking the direction of the connector (1 pin on the
bottom).
Relay printed
circuit board
Pass through
this hole
JN98901 JN98911
Front cover

(12) Insert the claw on the right side of the auto-cutter unit into the notch on the printer,
then fix it in place with the attached screw (1).
(13) Attach the front center cover from step 9 in its original position. (2 screws)
(14) Attach the front right cover removed at step 6 in its original position. (2 screws)
(15) Attach the operation panel removed at step 5 in its original position. (3 screws)
Note Be sure to connect the flexible cable that you disconnected as it was formerly
connected. The blue side of the tip is upwards.
(16) Attach the front top cover from step 4 in its original position. (2 screws)
(17) Close the top cover.
(18) Connect the power cord and turn on the power switch
on the printer.
Note Removing the auto-cutter unit
To remove the auto-cutter unit from the printer,
follow the installation steps in reverse order. If the
screws that fasten the auto-cutter unit are
removed, the unit may fall from the printer, so
hold the auto-cutter unit with your hand while
loosening the fastening screws.
For the JN98901, be sure to
pass the cable between the
metal plate and the pulley cover.
Metal
plate Pulley cover
Notch
Claw
JN98901