clare CS-PNC-10 User manual

Use the panel installation guide to verify proper system setup.
I
N
S
T
A
L
L
G
U
I
D
E
I
Wristband Lanyard
The CS-PNC-10 is a supervised portable device used to
trigger a panic alarm.
Features
• Water resistant housing
• Low battery indication
• Secure encrypted wireless transmissions
• Can be worn with a lanyard or wristband
Enroll the panic by placing the panel into wireless
enrollment mode and pressing the red panic button. Alternatively, the panic can
be enrolled by scanning its bar code using the Install Assist App or by entering its
8-character serial number on the interactive service provider’s web portal.
Operate by pressing the red panic button until the LED starts ashing.
Wear using the included lanyard or wristband. Note: To install the wristband you must rst
remove the clear plastic tube used to attach the lanyard.
CS-PNC-10
Panic Pendant

Specications
Physical
Housing Dimensions
Weight with Battery
1.5 x 1.2 x .6 inches (3.8 x 3.0 x 1.5 centimeters)
0.6 ounces (18 grams)
Environmental
Operating Temperature
Maximum Humidity
32°F to 120°F (0°C to 49°C)
85% non-condensing relative humidity
Sensor Specications
Frequency
Replacement Battery
Nominal Battery Life
Transmitted Indications
433.92 MHz
One Panasonic CR1632
4-6 Years
Low Battery, Panic, Supervision
Certication
RE603 FCC, IC, RCM, EN 60950-1, EN 300 220, EN 301 489, CE
Security Grade 2, CE Environmental Class 2
Specications subject to change without notice
2019-02-1842-01
941.238.3991
www.ClareControls.com
Original document below
https://bit.ly/2Nq8hf5