olympia electronics ΒS-576/L User manual

TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
AVERAGE CONSUMPTION
BEACON
12-24V DC
6 red LED
IP 20
26mA
EN 50130-4 , ΕΝ 55022
o
0 to 60 C
Up to 95%
2 year
165gr.
921576003_09_002
BEACON GENERAL PROPOSE WITH LEDs
ΒS-576/L
LAMP
ABS, transparent polycarbonate
101(diam.) X 78(H)mm
LED
GENERAL
The ΒS-576/L is an optical warning device that starts to blink immediately.
They are installed at a height of about 2-3m, indoors or outdoors but away from rain.
INSTALLATION
1. Unscrew counter clockwise and remove the red plastic cover of the beacon.
2. Remove the white plastic with the PCB.
3. On the back side, connect the power cable to the terminal block
(pay attention to polarity, see the sticker).
4. The power cable must pass through the respected enterance hole.Place the support materials
to mount the base.
5. Replace the removed parts from the previous steps and the device is ready to work.
1. 2.
3.
Beacon
ΒS-576/L
24V
-+
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
CONSTRUCTION MATERIAL
RELATIVE HUMIDITY
TYPICAL WEIGHT
GUARANTEE
DIMENSIONS
4.
Mounting hole
Power cable
enterance hole
Page 2 from 2
Page 1 from 2 921576003_09_002
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
HEAD OFFICE
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
[email protected]
Thank you for your trust in our products
Olympia Electronics - European manufacturer

TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
AVERAGE CONSUMPTION
BEACON
12-24V DC
6 red LED
IP 20
26mA
EN 50130-4 , ΕΝ 55022
o
0 to 60 C
Up to 95%
2 year
165gr.
921576003_09_002
BEACON GENERAL PROPOSE WITH LEDs
ΒS-576/L
LAMP
ABS, transparent polycarbonate
101(diam.) X 78(H)mm
LED
GENERAL
The ΒS-576/L is an optical warning device that starts to blink immediately.
They are installed at a height of about 2-3m, indoors or outdoors but away from rain.
INSTALLATION
1. Unscrew counter clockwise and remove the red plastic cover of the beacon.
2. Remove the white plastic with the PCB.
3. On the back side, connect the power cable to the terminal block
(pay attention to polarity, see the sticker).
4. The power cable must pass through the respected enterance hole.Place the support materials
to mount the base.
5. Replace the removed parts from the previous steps and the device is ready to work.
1. 2.
3.
Beacon
ΒS-576/L
24V
-+
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
CONSTRUCTION MATERIAL
RELATIVE HUMIDITY
TYPICAL WEIGHT
GUARANTEE
DIMENSIONS
4.
Mounting hole
Power cable
enterance hole
Page 2 from 2
Page 1 from 2 921576003_09_002
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
HEAD OFFICE
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
[email protected]
Thank you for your trust in our products
Olympia Electronics - European manufacturer