Clarke SV1B User manual

Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
MODEL NO: SV1B
PART NO:
PART NO: 8133811
SV1B SAFETY VISOR
INTRODUCTION
Thank you for purchasing this CLARKE Safety Visor. Before attempting to use this product, please read this manual
thoroughly and follow the instructions carefully.
This product is designed for face and eye protection against high-speed particles of low energy impact. The visor is
designed to be lightweight and comfortable to wear but is not unbreakable.
The visor will not provide protection against fine dust, gas, ultra violet or infra red radiation, ionising radiation, liquids
under pressure or other severe hazards.
SAFETY PRECAUTIONS
• Inspect the visor frequently, as a pitted or scratched visor reduces vision, reduces protection and
therefore should be replaced immediately.
• Additional eye protection such as impact resistant safety spectacles or goggles should be worn when
using this visor for more hazardous work.
• This visor is not suitable for welding, laser cutting or grinding.
• The protective visor is breakable and will not protect against severe impact hazards.
• Use this visor for face and eye protection against sparks and splashing of chemicals.
• NEVER place this product on a hot surface.
• When necessary, use identical replacement parts to ensure the safety of the product is maintained.
• DO NOTuse if any part of the product is cracked or broken.
CARE AND MAINTENANCE
Damaged components must be replaced immediately to avoid risk of eye and face injuries. A cracked, pitted or
scratched visor will reduce vision and seriously reduce the level of protection and it should be replaced.
The visor can be wiped with soapy water or a household glass cleaner when dirty. Apply the cleaner with a clean cloth
or paper towel. DO NOT use solvents. NEVER use tools or other sharp objects to remove foreign material from the visor.
Store the safety visor at room temperature out of direct sunlight.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please
keep your receipt which will be required as proof of purchase.
This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the
purpose for which it was intended.
Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission.
This guarantee does not effect your statutory rights.
GC0822

Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
PREPARATION FOR USE
DECLARATIONS OF CONFORMITY
1. Remove all protective film from the transparent visor
before use and remove the visor fixing nuts.
2. Engage the visor with the swivel tab at the front.
Slide the visor slots onto the four swivel tabs and turn
to secure the visor. Replace visor fixing nuts.
3. The headband should be adjusted to fit the
wearer’s head. To do this, turn the adjustment knob
either left or right to expand or contract the
headband.
4. The top headband can be adjusted by bending the
strap and positioning the peg in the appropriate
hole to suit the user.