Table of Contents
1General........................................................................................................................................................... 3
2Check Delivery Conditions.............................................................................................................................. 3
3Intended Use .................................................................................................................................................. 4
4Fixing on the Machine .................................................................................................................................... 5
5Adjusting the Bridge Guard ............................................................................................................................ 5
6Components and Controls.............................................................................................................................. 6
7Safety.............................................................................................................................................................. 6
7.2.1 Safe Position of the Hands when Feeding the Workpiece............................................................................. 7
8Handling during Knife Change ........................................................................................................................ 8
9Maintenance and Care ................................................................................................................................... 9
10 Scrapping and Disposal................................................................................................................................... 9
List of Figures
Figure 1: Dimensions.................................................................................................................................................................. 4
Figure 2: Fixing dimensions and drilling diameters .................................................................................................................... 5
Figure 3: Adjustment (K)............................................................................................................................................................. 5
Figure 4: Adjustment (H) ............................................................................................................................................................ 5
Figure 5: Bend compensation..................................................................................................................................................... 5
Figure 6: Stroke and damping .................................................................................................................................................... 6
Figure 7: Components & controls............................................................................................................................................... 6
Figure 8: Planing of flat and wide workpieces............................................................................................................................ 7
Figure 9: Edge planing of workpiece heights < 75 mm............................................................................................................... 7
Figure 10: Planing workpiece sides ............................................................................................................................................ 7
Figure 11: Planing of workpieces with small cross-sections and planing of workpiece sides..................................................... 8
Figure 12: Planing short parts .................................................................................................................................................... 8
Figure 13: Bevelling along the dressing fence ............................................................................................................................ 8
Revisions:
