Clear One COLLABORATE Pro 300 User manual

COLLABORATE®Pro 300
Quick-Start Guide

COLLABORATE PRO 300
2
COMPONENTS INCLUDED
COLLABORATE Pro 300
COLLABORATE
Pro 300 codec with
power supply, VESA
Mounting Plate, and
COLLABORATE
Remote Control with
USB dongle
910-2100-003
UNITE 200 PTZ
camera, power supply,
USB cable
Note: The remote control
inside the camera box
is only for any advanced
configuration in the
camera, if required.
For the camera’s control,
use the COLLABORATE
Codec Appliance’s remote
control.
910-3001-200
CHAT 150C with USB
cable

QUICK-START GUIDE
3
CONNECTING PERIPHERALS
Connect the CHAT 150C, Unite Camera, monitor(s), and network to the
COLLABORATE Pro 300 codec as shown.
Mini HDMI 1080P or
720P Video/Audio Out
(for Primary Monitor)
Mini Display
Port (for 2nd
Monitor)
Ethernet
Connection
to Network
DC In
USB Port for
UNITE Camera
USB 3.0 Port for
CHAT 150C
DC In

COLLABORATE PRO 300
4
Plug dongle into USB Port
CONNECTING REMOTE CONTROL DONGLE
Install batteries in the remote control and plug in the USB dongle into the
codec.
Note: To maximize range of the remote, verify that the dongle and the
UNITE camera USB are plugged into opposite sides of the codec.

QUICK-START GUIDE
5
CONFIGURING DISPLAY SETTINGS
After all peripherals are connected to the unit, turn the unit on.
Once COLLABORATE Pro is loaded, the Setup Wizard appears. The
Setup Wizard lets you configure the system name, time, and network,
proxy, and Spontania settings. After the Setup Wizard is complete, using
the remote control, navigate to the display settings:
Settings > System > Display
According to your monitor capabilities, set to the maximum supported
resolution. If 2 monitors are connected to the unit, the display mode is
automatically changed to dual mode and you can set both monitors’
resolutions.

COLLABORATE PRO 300
6
CONFIGURING AUDIO SETTINGS
The COLLABORATE Pro 300 audio input and output are set to the CHAT
150C.
Verify this in COLLABORATE Settings > System > Audio

QUICK-START GUIDE
7
CONFIGURING NETWORK SETTINGS
Using your remote control, navigate into the network settings:
Settings > System > LAN
The COLLABORATE Pro 300 obtains its IP automatically by default from
a DHCP server.
Uncheck the Obtain Address from DHCP checkbox to manually
configure network settings.

COLLABORATE PRO 300
8
CLEARONE CONTACTS
Europe & Oceana
Tel: [phone]
e-mail: [email protected]
Asia Pacific
Tel: [phone]
e-mail: [email protected]
HEADQUARTERS:
Salt Lake City, UT USA
5225 Wiley Post Way
Suite 500
Salt Lake City, UT 84116
Sales: 800-707-6694
Toll Free: 800.945.7730
Fax: [phone]
e-mail: [email protected]
TechSales
Tel: [phone]
e-mail: [email protected]
Technical Support
Tel: [phone]
e-mail: [email protected]
Latin America
Tel: [phone]
e-mail: [email protected]
Middle East
Tel: [phone]
e-mail: [email protected]
© 2017 ClearOne, Inc. All rights reserved - http://www.clearone.com/.
Information in this document is subject to change without notice. QSG-0020-001 Revision 1.3, February, 2017