Clear One XAP TH2 User manual

XAP|TH2
®
XAP Telephone Interface
A telephone interface for ClearOne's industry-leading XAP
professional conferencing systems. The XAP TH2 enables
conference call functionality for XAP installations with its single
telephone line connection. Up to 16 units can be linked for greatly
expanded conferencing capability.
THE CLEAR CHOICE
FOR PROFESSIONAL
AUDIO CONFERENCING
APPLICATIONS
Conference Rooms
Boardrooms
Courtrooms
Distance Learning Facilities
Convention Centers and Hotels
Training Rooms
Telemedicine Facilities
Houses of Worship
ADVANTAGES
Superior Audio Performance
+Digital signal processing technology ensures crystal clear audio
+Full-time echo cancellation eliminates telephone line echo
+Automatic level control
+Digital anti-alias filter minimizes hum and Central Office switching noise
Configuration Flexibility & Scalability
+Connects to ClearOne's XAP and PSR products through expansion bus port
+Conference up to 16 callers in a XAP installation with multiple TH2 units
+Configure through included G-Ware™ software, or through RS-232 port
Ease of Use & Control
+Speed dial stores 10 frequently dialed numbers
+Incoming call ringing is heard through the loudspeaker
+Selectable auto-answer and auto-disconnect
+Users can dial telephone numbers, access voice mail, pagers, etc. without the
use of a separate telephone device through integrated DTMF (touch-tone)
dialing
+Software-selectable country configurations
PROFESSIONAL CONFERENCING
DATA SHEET <

>XAP TH2 BACK PANEL
XAP®TH2 DATA SHEET <
>CLEARONE LOCATIONS
Headquarters:
Salt Lake City, UT USA
5225 Wiley Post Way
Suite 500
Salt Lake City, UT 84116
Tel: [phone]
800-945-7730
Fax: [phone]
[email protected]
Latin America
Tel: [phone]
[email protected]
EMEA
Tel: [phone]
[email protected]
APAC
Tel: [phone]
[email protected]
© 2007 ClearOne Communications Inc. All rights reserved. Other product names may be trademarks of their respective owners. Information in this document subject to change without notice. 802-151-301 Revision 3.3
>SPECIFICATIONS
Audio Performance
Conditions: Unless otherwise specified, all
measurements are performed with a 22 Hz to
22 kHz BW limit (no weighting). Transmit limiter
and Receive ALC disabled
Frequency Response: 250 Hz to 3.3 kHz ±1 dB
THD+N: <0.2% re max level
SNR: >62 dB re max level
Telco Line Echo Cancellation
Tail time: 31 ms
Null: 55 dB nominal
Expansion Bus In/Out
Proprietary Network
RJ-45 (2), 115.2 kbps,
110 k
ž Impedance
Category five twisted-pair cable
80' (24 meters) maximum cable length between
any two PSR1212s, XAP 800s or XAP 400s
RS-232
DB-9 female
9,600/19,200/38,400 (default)/57,600 baud rate;
8 bits, 1 stop, no parity
Hardware flow control on (default)/off
Control/Status
DB-25 female
Inputs: active low (pull to ground)
Outputs: open collector, 40 VDC max,
40 mA each
+5 VDC (300 mA over-current protected)
Telco Line
RJ-11
POTS (plain old telephone service) or analog
extension from a PBX
A-lead supervision provided
Telco Set
RJ-11
Connect analog telephone set
A-lead supervision provided
Transmit Input
Push-on terminal block, balanced, bridging
Impedance: >10 k ž
Nominal Level: 0 dBu
Maximum Level: 15 dBu
Receive Output
Push-on terminal block, balanced
Impedance: <50
ž
Nominal Level: 0 dBu
Maximum Level: 19 dBu
Device ID
4-position DIP switch
Set-up Software
G-Ware
Power Input Range
Auto-adjusting
100-240 VAC; 50/60 Hz
Power Consumption
15 W typical
Approvals
FCC, CSA, IC, CE, NOM, ACA, SABS,
JATE
Dimensions (LxDxH)
17.25" x 10.25" x 1.75"
43.8 x 26 x 4.5 cm
1
2
3
4
5
6
7
8
Typical Installation in XAP 800 System
>INSTALLATION