CNC4PC C34G320X User manual

USER’S
MANUAL
VER. 2
C34G320X BOARD
Rev. 6
JUNE 2018

User’s Manual Page i
USER'S MANUAL
TABLE OF CONTENTS
Contents page#
1.0 OVERVIEW.....................................................................................................................1
2.0 FEATURES.....................................................................................................................1
3.0 BOARD DESCRIPTION..................................................................................................1
4.0 JUMPER TO SELECT (REQ OR NOT REQ)..................................................................2
5.0 JUMPER TO SELECT THE ENABLE.............................................................................3
6.0 PINOUT...........................................................................................................................4
7.0 DIMENSION....................................................................................................................5

User’s Manual Page 1
1.0 OVERVIEW
This board simplifies connecting Gecko G320/340, and G320X Stepper Drivers to RJ45
connector boards, such as the C32, C62, C76, M16 and C82 boards. As just a regular
twisted pair RJ45 cable needs to be used.
2.0 FEATURES
•Pin Header of 8 pins for Connection of Driver.
•RJ45 Connector for the axes.
•RJ45 Connector for encoders
•Terminals to power the encoder
3.0 BOARD DESCRIPTION

User’s Manual Page 2
4.0 JUMPER TO SELECT (REQ OR NOT REQ)
If using an encoder that demands less of 50mA and external power supply is not required, set
jumper to the not required position.
NOT REQ
Otherwise, add and external power supply and set the jumper to REQUIRED.
REQ

User’s Manual Page 3
5.0 JUMPER TO SELECT THE ENABLE
The drivers can be set to be enabled by the board only while the system is active. For
this set the jumper to SOFT ENABLE.
SOFT ENABLE
Hardware Enable will keep the driver enabled all the time.
HARD ENABLE
WIRING SAMPLE
http://cnc4pc.com/Tech_Docs/WS_37.pdf
Note: This wiring is just to illustrate a sample product application. Specific wiring may
vary from system to system. It is the user’s responsibility to implement it correctly.

User’s Manual Page 4
6.0 PINOUT
STEP and DIR RJ45
PIN RJ45
FUNCTION
1
NOT USED
2
STEP
3
NOT USED
4
GND
5
ERR/RES
6
DIR
7
NOT USED
8
5V
ENCODER RJ45
PIN RJ45
FUNCTION
1
GND
2
5V
3
NOT USED
4
NOT USED
5
NOT USED
6
A+
7
NOT USED
8
B+

User’s Manual Page 5
7.0 DIMENSION
All dimensions are in Millimeters.
DISCLAIMER
Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC
nor Arturo Duncan are liable for any accidents resulting from the improper use of these
devices. This board is not a fail-safe device and it should not be used in life support
systems or in other devices where its failure or possible erratic operation could cause
property damage, bodily injury or loss of life.