CNC4PC C34HS2 User manual

USER’S
MANUAL
VER. 1
C34HS2 BOARD
Rev. 1
OCTOBER, 2020

User’s Manual Page i
USER'S MANUAL
TABLE OF CONTENTS
Contents Page #
1.0 OVERVIEW.....................................................................................................................1
2.0 FEATURES.....................................................................................................................1
3.0 BOARD DESCRIPTION..................................................................................................1
4.0 JUMPER TO SELECT THE ENABLE.............................................................................2
5.0 ALARM TERMINAL........................................................................................................4
6.0 WIRING SAMPLE...........................................................................................................4
7.0 PINOUT...........................................................................................................................5
8.0 DIMENSIONS..................................................................................................................6

User’s Manual Page 1
1.0 OVERVIEW
This board interface is used for the connection between C82, C76, M16D and Closed
Loop Steppers DRIVE.
2.0 FEATURES
•RJ45 Driver Input Connector
•Select Jumper for Hard Enable or Soft Enable.
•Alarm terminal
•Select jumper for signal differentials.
•Select Jumper active Low and active High
•Adjustable resistor to allow adjusting the fault sensibility
3.0 BOARD DESCRIPTION

User’s Manual Page 2
4.0 JUMPER TO SELECT THE ENABLE
Use Software Enable to keep the driver active only while the system is active.
Set of jumpers as shown in the image.
SOFT ENABLE
Use Hardware Enable to keep the driver enabled all the time.
Set of jumpers as shown in the image.
HARD ENABLE
JUMPER TO SELECT THE DIFFERENTIAL
If working the inputs of STEP and DIR as differentials signals, you have to use the board, set
jumper as shown in the image.
DIFERENTIAL

User’s Manual Page 3
If not use the differential signal for STEP & DIR, set jumper as show in the image.
STEP & DIR
JUMPER TO SELECT ACTIVE LOW AND ACTIVE HIGH
1-2: ACTIVE LOW
2-3: ACTIVE HIGH

User’s Manual Page 4
5.0 ALARM TERMINAL
6.0 WIRING SAMPLE

User’s Manual Page 5
7.0 PINOUT
C34HS CONNECTOR RJ45
RJ45 Pins
Function
1
NOT USED
2
PUL+
3
NOT USED
4
GND
5
ERR
6
DIR+
7
NOT USED
8 (5V)
EN+

User’s Manual Page 6
8.0 DIMENSIONS
All dimensions are in Millimeters.
DISCLAIMER
Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC
nor Arturo Duncan are liable for any accidents resulting from the improper use of these
devices. This product is not a fail-safe device and it should not be used in life support
systems or in other devices where its failure or possible erratic operation could cause
property damage, bodily injury or loss of life.