Coaster 206103 User manual

206103
DRESSER
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
PAGE 1 OF 5 REVISION 0: 06/05/2018

ASSEMBLY TIME 10 MINUTES
ITEM: 206103 ASSEMBLY INSTRUCTIONS
PARTS IDENTIFICATION
ASSEMBLY TIPS:
1.Remove hardware from box and sort by size.
2.Please check to see that all hardware and parts are present prior to start of assembly.
3.Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
Warning!
1.Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2.This product is for home use only and not intended for commercial establishments.
ADRESSER 1 PC
4 PCS
FIGUREPART NAME QTY
LEG
CENTER SUPPORT LEG
WITH LEVELER 1 PC
HARDWARE IDENTIFICATION
1ALLEN WRECH
(4mm - RBW) 1 PC
4 PCS
FIGUREHARDWARE NAME QTY
BOLT
(Ø5/16" x 90mm - RBW)
2
3
4
LOCK WASHER
(Ø5/16" - RBW)
FLAT WASHER
(Ø5/16" x 19 x 1.5mm - RBW)
4 PCS
4 PCS
NOTE: PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY
PROCESS; HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.
B
C
PAGE 2 OF 5
www.coastercompany.com

Please take out the legs from
the last drawer
ITEM: 206103 ASSEMBLY INSTRUCTIONS
STEP 1
A
STEP 2 A
B
4
3
2
1
C
STEP 3
PAGE 3 OF 5
www.coastercompany.com

Complete
STEP 4
ITEM: 206103 ASSEMBLY INSTRUCTIONS
PAGE 4 OF 5
www.coastercompany.com

ANTI-TIPPING INSTALLMENT INSTRUCTIONS
1. Attach one of the mounting brackets securely to the back edge of the furniture. Use the short screw.
2. Determine where the furniture is to be placed and mark location on the wall for the mounting bracket screw
hole approximately 2" below the bracket mounted to the edge of the furniture.
4. Position the bracket over the wall plug and use the long screw to securely attach the bracket to the wall.
5. Place the furniture so the bracket on the back edge is in line with the bracket on the wall.
6. Lace an end of the cable tie down through each bracket. Bring both ends together and slide the beaded end
of the cable tie through the keyhole shaped slot on the other end until snug. Pull down on the beaded end
until it snap locks into the keyhole slot.
7. To double lock return the beaded end back through the keyhole as shown.
8. Check to make sure the cable tie is securely laced and locked to the brackets.
3. Drill a 3/16" hole in the wall. Press the plastic wall plug into the hole and gently tap until the flange on the
wall plug is against the wall surface.
PAGE 5 OF 5
www.coastercompany.com