Coaster 4137 User manual

4137
DROP LEAF PEDESTAL BASE TABLE
COASTER FINE FURNITURE
ASSEMBLY INSTRUCTIONS
www.coastercompany.com
PAGE 1 OF 3
REVISION 0 : 07/24/2006
REVISION 1 : 12/19/2011
REVISION 2 : 09/20/2014

ALLEN WRENCH
2
4
3
PAGE 2 OF 3
LONG BOLT
www.coastercompany.com
4PCS
2. Please check to see that all hardware and part are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
2. This product is for home use only and not intended for commercial establishment.
ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS :
1. Remove hardware from plastic bag and sort by size.
ITEM :
1
BN1
AN
HARDWARE IDENTIFICATION:
PARTS IDENTIFICATION:
immediately.
Warning !
4137
TABLE TOP
PEDESTAL BASE
1PC
1PC
BN2 PEDESTAL LEG WITH INSERT 1PC
DN MOUNTING BAR 2PCS
1PC
5
PAN HEAD SCREW 8PCS
6
4PCS
7
8LEVELER
LOCK WASHER
FLAT WASHER
4PCS
4PCS
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY
PROCESS. HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.
SHORT BOLT
WOOD PLUG 2PCS
2PCS
CN
PEDESTAL LEG WITH HOLES
1PC

4137
STEP 3
STEP 1
ITEM :
Flip table over using two people to lift and flip this table.
Adjust leveler to touch the floor.
PAGE 3 OF 3
STEP 4
www.coastercompany.com
STEP 2
ASSEMBLY INSTRUCTIONS
216
DN
BN2
AN
CN
1.1 Align and fasten pedestal base (CN) to pedestal legs
(BN1 & BN2) using long bolt (2) and tighten with Allen
wrench (1).
1.2 Insert wood plug (6) to cover the open hole of pedestal
leg (BN1 & BN2).
BN1
Align and fasten mounting bar (DN) to the top of pedestal
base (CN) and leg (BN1 & BN2) using short bolt (3), lock
washer (4) and flat washer (5) and tighten with Allen wrench
(1).
3.1 Place table top (AN) upside down on soft surface.
Align and position mounting bar (DN) onto the marking at
the bottom of table top (AN). Then fasten using pan head
screw (7) and tighten with Phillips head screw driver (Not
Included).
3.2 Screw in leveler (8) to the bottom of pedestal base
(CN) and leg (BN1 &BN2).