Coaster Malia 122341 User manual

Fine Furniture for every stage of life
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
PAGE 1 OF 6
REVISION 0: 05/05/2023
COASTERFURNITURE.COM
Dining Table
122341

A TOP
1PC
PAGE 2 OF 6 COASTERFURNITURE.COM
B LEG
C TOP TRESTLE BAR
D STRETCHER BAR
E STRETCHER
F CROSSBAR
4PCS
2PCS
2PCS
2PCS
1PC
PARTS IDENTIFICATION
ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
WARNING!
2. This product is for home use only and not intended for commercial establishments.
ASSEMBLY TIME
1. Don’t attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
15 MINUTES
ITEM:122341
HARDWARE IDENTIFICATION
1
BIG ALLEN WRENCH
(M5 X 65mm - BLK)
22PCS
2SMALL BOLT
(M6 x 50mm - RBW) 4PCS
3BIG LOCK WASHER
(M8 - RBW) 22PCS
5WOOD DOWEL
(M10 X 35mm - NTL) 14PCS
BIG BOLT
(M8 x 50mm - RBW)
4SMALL LOCK WASHER
(M6 - RBW) 4PCS
6
SMALL ALLEN WRENCH
(M5 X 65mm - BLK)
7
1PC
1PC

PAGE 3 OF 6
STEP 1
COASTERFURNITURE.COM
D
STEP 2
B
36
1
5
C
1
6
3
5
ITEM:122341
ASSEMBLY INSTRUCTIONS

PAGE 4 OF 6 COASTERFURNITURE.COM
STEP 3
STEP 4
F
7
2
4
6
E
5
3
1
7
5
2
4
ITEM:122341
3.1 3.2
ASSEMBLY INSTRUCTIONS

PAGE 5 OF 6 COASTERFURNITURE.COM
STEP 5
A
6
3
1
STEP 6
ITEM:122341
ASSEMBLY INSTRUCTIONS
COMPLETE
* Do not fully tighten the bolts (hardware#1) until all the 8pcs bolts have been screwed into place.

Once opening is shown, please slide back and the extension
top can be popped up
To put away the extension tops “please first pull back on the
extensiontop and push down and the extension
top can be stored below the table”
Before After
Pull down
from here
1
2
31
2
3
1
2
31
2
3
PAGE 6 OF 6 COASTERFURNITURE.COM
* To avoid scratching the table top. To extend the extension tops “please first pull down on the
bottom of the extension top so it shows a slight opening”
Pull down
from here
STEP 7
STEP 8 STEP 9
ITEM:122341
ASSEMBLY INSTRUCTIONS

Note: Dimension tolerance ±5%
86.50"35.50"
22.00"
18.00"
50.75"
45.50"
25.75"
30.00"
13.75" 59.00" 13.75"
27.50"
COASTERFURNITURE.COM
ITEM:122341
21.25"
1.50"