Coleman Insta-Clip 9392-142 User manual

Assemble Frame
–You will need to assemble and connect
one pole at a time to the hub.
–Do not completely assemble poles.
a) Beginning at spring-clip end of pole,
assemble all but the last shock-corded
section.The pole and one section
should curve downward (Illus. 2).
b) Insert the spring-clip end into one of
the hub ports until it clicks into
position (Illus. 1, 2).
c) Repeat for each of the five remaining
poles (Illus. 2).
14’x12’ Insta-ClipTM Screen House
1
WhenYou Are ReadyTo Assemble
Your Shelter
–Select a level campsite clear of rocks,
branches and other hard or sharp objects.
–Do not assemble your shelter under trees.
–For easier setup, two or more people are
recommended.
–Place fabric in center of selected location
and assemble poles above fabric.
POLE ASSEMBLY PARTS
Instructions apply to Part Number 9392-142
Poles Part No. 9392-224
Hub Part No. 9392-223
Illustration 2
Partially assembled
frame locked into hub
Illustration 1
Poles inserted
into hub
Hub
Hub
®
Spring Clip

3Stake Down Shelter
a) Adjust poles to pull shelter taut
and insert larger stake
downward through fabric
loop at end of each pole
(Illus. 5).
b) Attach guylines to
fabric and stake
down using metal
stakes (Illus. 6).
2
PRINTED IN SRI LANKA Rev. 3/04
Things You Should Know
• Never store shelter, even for a short period of time, without drying
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your shelter.Use separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON FABRIC OR STAKE LOOP TO REMOVE STAKE.
• POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING
STORAGE.
• Do not leave your shelter set up for weeks at a time. Be aware that
exposure to ultraviolet rays of the sun can seriously damage material
and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM SHELTER FABRIC. This shelter meets the flammability
requirements of CPAI-84. Fabric will burn if left in continuous contact with
any flame source. Application of any foreign substance to the fabric may
cause flame-resistant properties to become ineffective.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
Attach Shelter to Frame
a) Clip center of shelter roof to bottom
of hub.
b) Clip shelter to frame, positioning
doors in desired direction (Illus. 3).
c) Corners have two clips, so snap
one into clip bracket.
d) To fully extend each pole, interlock
all shock-corded pole sections.
e) Insert straight pin into base of pole
(Illus. 4). Illustration 3
Illustration 6
Assembled shelter
with guylines extended.
Illustration 4
Insert straight pin into
base of pole Illustration 5
Insert stake through
stake loop
®
Guyline