Coleman SMOKE GENERATOR User manual

FOR BEST RESULTS FOLLOW THESE STEPS
Fill the smoke generator with pellets
LOADING
SMOKE GENERATOR
085-2343-0/ FS-6145C www.colemanbbqs.com
Last Updated: 2020-09-30 WZ
TIP:
Don’t overfill the generator. If the pellets are piled above the dividers, the burn can jump rows, which will
reduce the length of smoke time.
X
LIGHTING
Place the smoke generator on a flat surface or resting flat on your grill.
Use a propane torch to light the pellets through the starter hole.
Hold the torch to the pellets for a long enough time to properly ignite them (around 45 seconds).
Let the flame burn for 5-10 minutes.
TIP:
If you don’t have a propane torch, you can add gel alcohol to the pellets near the starter hole and ignite it
with a BBQ lighter.
Coleman Smoke Generator Draft 2 EN_colored.indd 1Coleman Smoke Generator Draft 2 EN_colored.indd 1 2020-10-01 2:20 PM2020-10-01 2:20 PM

©2021 The Coleman Company, Inc.
Coleman®, , and are registered trademarks of
The Coleman Company, Inc. utilisées sous license.
SMOKING:
SMOKE GENERATOR
085-2343-0/ FS-6145C www.colemanbbqs.com
Last Updated: 2020-09-30 WZ
Softly blow out the flame (after you’ve waited 5-10 minutes.)
Close the grill lid.
TIPS:
Don’t handle the smoke generator while it’s in use. If you must, use protective heat resistant gloves.
Smoke times range from 4-8 hours, but can vary depending on type of pellets, amount of dust used, wind,
venting, and ambient temperatures within your BBQ/Smoker.
Where applicable, ensure that BBQ/Smoker air vents are open before closing your lid.
Do not allow food drippings to come in contact with the Smoke Generator.
Coleman Smoke Generator Draft 2 EN_colored.indd 2Coleman Smoke Generator Draft 2 EN_colored.indd 2 2020-10-01 2:20 PM2020-10-01 2:20 PM