Coleman QUICKPUMP User manual

220-240V QUICKPUMP™
UNIT INSTRUCTIONS
(Photo may vary from actual product.)
Warning
Things You Should Know
•Children should be supervised to ensure that
they do not play with the appliance. This
appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
•Cleaning and user maintenance shall not be
made by children.
•READANDSAVETHESEINSTRUCTIONS.
•Follow the instructions carefully on articles
to be inflated, never exceed recommended
pressure. Bursting items can cause serious
injury.
•To reduce the risk of fire for electric shock, do
not use this pump with any solid-state speed
control device.
•Do not use under wet conditions. Keep away
from water.
•Never look into or point any opening toward
your eyes while pump
is operating.
•Do not attempt to put any objects into the
inflation or deflation port at any time.
•Never leave pump unattended while in use.
•Do not leave pump connected to the power
supply when not in use.
•Never twist the cord.
•Never allow sand, paper, debris or small
articles to be sucked into pump while
operating.
•Let pump cool before storing the pump inside
the box after use.
•Allow pump to cool for 30 minutes after each
10 minutes of continuous operation.
•Do not attempt to defeat this safety feature.
•Unplug or disconnect the appliance from the
power supply before servicing.
•Do not operate any pump with a damaged
cord or plug. Discard pump or return to an
authorized service facility for examination
and/or repair.
•Do not run cord under carpeting. Do not
cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic
area where it will not be tripped over.
•If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or similar qualified person in order to
avoid a hazard.
DONOTEXCEED10MINUTESOF
CONTINUOUSOPERATION.ALLOW
30MINUTESOFFBETWEENEACH
OPERATION.
CAUTION:Donotblocktheairportals
duringoperation,thiscoulddamagethe
motor.
•Carefully inspect the pump for damage before
first use and every use thereafter. Do not use
if found damaged.
•Check the plug pins and cable if these are
damaged do not use. The supply cord cannot
be replaced. If the cord is damaged the
appliance should be scrapped.
•Do not change the plug in any way.
•Power supply must be 220-240 volt AC.
•Keep unit out of reach of children.
•Do not expose to rain or sunlight. Household
use only.
•This pump is a high-volume, low-pressure
pump. It is intended to inflate items requiring
low pressure (such as inflatable beds,
inflatable rafts, air mattresses, etc.).
•For fast inflation and maximum motor
cooling, always use the largest size nozzle
possible.

1. To begin ination, open external cap and pull
rmly on the lanyard to extend out. This will
open internal yellow seal. (Fig. 1)
2. Attach adapter nozzle to ination end of pump.
Insert pump and turn on. (Fig. 2)
Note: The pump may look different from yours.
It is for illustration purposes only.
3. When fully inated, seal valve by pushing in
with pump nozzle. This will seal the internal
yellow stopper and keep air from escaping
while closing cap. Gently twist adapter sleeve
to right while backing pump out of valve. (Fig. 3)
4. Fully remove pump and close external cap.
Valve should appear depressed into itself.
(Fig. 4)
Fig. 5
1. Remove adapter nozzle
from ination end and
attach to deation side
of pump. Repeat same
steps as ination. This
will draw the air out
quickly. (Fig. 5)
• Attach pinch valve
adapter to inflation end of
pump.
• Insert pinch valve adapter
into pinch valve. (Fig. 6)
• Make sure tip of adapter
is extended past inner “Flap” inside of
valve. Turn pump on.
• When fully inflated, remove pump from
valve and seal valve.
Fig. 6
Inflating Coleman®Double
Lock™ Valve
Deflation
Inflating Standard Pinch
Valve
Fig. 4
Fig. 3
Fig. 2
Fig. 1
4010045467 (ECN20060957-02)
•Caution - Risk of fire and electric shock! Do
not operate for more than 10 minutes. Allow
30 minutes off between each operation.
Note:Pumpwillnotworkonstemvalves
orneedlevalvescommonlyusedonbike
tires,basketballs,etc.
Please call or write us with any comments or questions:
Coleman Brands Pty. Ltd.
Unit 5-6, 13 Lord Street,
Botany NSW 2019
Australia
Telephone: [phone]
Email: [email protected]
www.colemanaustralia.com.au
Made in China
© 2017 The Coleman Company, Inc. All right reserved.
Coleman®, , and are registered trademarksand
QuickPump™, Double Lock™, QuickBed™ and Wrap ‘N’ Roll™ are
trademarks of The Coleman Company, Inc.