ColorKey Mover Beam 4 Zoom User manual

Mover Beam 4 Zoom
User’s Manual

I. Preface
Thank you for purchasing the ColorKey Mover Beam 4 Zoom. Please read these instructions
carefully before use. O perating this fixture according to these instructions is important to avoid
any possible damage or accidents caused by misuse.
Packing Content
Ø One light
Ø One DMX cable
Ø One power cable
Ø User manual
Note: Please check if all the contents are completed after unpacking, then, check if the light is
undamaged.
Safety specifications
Caution! Opening this unit voids warranty. Contact ColorKey for any service requests.
Warning! To avoid electrical shock, be sure to disconnect power before any service or when moving or setting up the
fixture.
Caution! Avoid direct eye exposure with the fixture when on.
Ø This fixture is for indoor use only.
Ø This fixture must be installed a minimum distance of 5 meters (16’4”) away from any lighted objects.
Ø Do not install or operate this fixture near flammable materials.
Ø This device must be installed, operated, and maintained by a qualified professional.
Ø Do not touch the fixture with bare hands during operation as the surface temperature of the fixture can exceed
60˚C (140˚F). Turn off power and wait 15 minutes for the fixture to cool before attempting to touch it.
Ø Please check if the voltage is in accordance with the rated power before installing.
Do not operate this fixture if the power cord has been damaged. Turn off fixture and replace with a power cord of
similar rating.

Technical Specifications
Power supply: AC100V-240V; 50/60HZ
Power consumption: 68W
Light source: 4x12W RGBW 4-in-1 LED units
Life span: 50,000-100,000 hours
Effect: RGBW color mixing
Beam angle: 10˚ - 60˚
Channel: 14ch/16ch
Control: Auto; Sound Active; DMX512; Master / Slave
Pulse frequency: 0-10HZ
Dimming: 0-100%
Pan: 540˚
Tilt: 270˚
IP rate: IP20
II. Menu Guide

III. DMX Channel Chart
16 channel mode
14 channel mode

1st light
2nd light
3rd light
Resistor
IN
OUT
IN
OUT
IN
OUT
120Ω 1W
IV. Appendix
The light is available to receive the DMX512 signal, connect the DMX connector to the panel which marked with “DMX
IN”，and connect it to the next light. then, connect to the “DMX IN” of next light from the “DMX OUT”. The DMX signal
terminator is recommended when the lighting signal is connecting. It will avoid to interfere the signal which caused by
the electrical noise, DMX terminator is a XLR connector, connect with a 120Ω resistor between the pin 2 and pin 3 of
the XLR connector, and connect it to the OUTPUT socket of the final light. see picture:
V. Warranty & Support
ColorKey offers a 1-year limited warranty. Please visit our website at www.ColorKeyLED.com for support.
Mixware, LLC
9790 Glenoaks Blvd, Ste 7
Sun Valley, CA 91352
Tel: [phone]
Fax: [phone]
www.mixware.net
[e-mail]
© 2018 Mixware, LLC. ColorKey and the ColorKey logo are registered trademarks of Mixware, LLC.