Comelit GDX User manual

Setup Guide
Getting Started with the GDX Gateway
Issue 1.0 Mar 2023
Technical Support [email protected]
T: [phone] —Option 2
Training [email protected]
T: [phone] —Option 1

Layout
Layout
Gateway Layout
FRONT VIEW
REAR VIEW
PAGE | 2

Layout continued...
Layout continued...
SIDE VIEW
CAN Bus Connector Data
Pin numbering Connector type
20-pin dual-raw plug with push-in spring connections.
Locking: screw flange.
Pitch: 2.54 mm.
Wire cross section: AWG 20 – AWG 30.
PIN Signal designation:
1. CAN_H
2. ISO_GND_A
3. CAN_L
Pins 4-20 are not used
PAGE | 3

Setup
Setup
Setup Instructions
1. The DC terminal block adaptor plugs into the Gateway (DCIN) and is connected to a DC
power source.
Wiring:
positive DC IN
negative 0V
2. Insert the power supply plug into the GDX Gateway DC IN jack and turn the power plug
clockwise to lock.
3. Turn the Gateway ON and OFF:
i Press the Power button once to power ON.
ii Press and hold the Power button until power OFF.
4. Please refer to GDX technical support team before attempting a Hardware Reset.
5. The Status LEDwill show:
i AMBER solid light:System is booting up.
ii GREEN solid light:System is ready.
PAGE | 4